20 Most Recent
1999 Volvo S80 - Page 5 Questions & Answers
Remote not working
You Didn't say whether you replaced the battery in the remote,but I would try that first
Turbo Boost sensor A
hi what was the code (p 0244)sounds like you need to replace the the turbo wastegate valve .sounds to me like its overboosting as if the charge from the turbo gets too hot the engine will misfire thus causing damage to engine ,the waste gate valve is there to prevent over pressurisation
All drivers door controls have stopped working
Hi. Best guess is the door loom. Open the door and there is a rubber grommet between the body and the door where all the wires run. The wiring can break inside the rubber grommet so you have to unclip it from one end and gently pull it back to reveal as much of the loom as you can. If it looks ok gently pull each one in turn and see if any come loose. Jon.
Instrument light do not work
very common fail search for a place that does dash repairs it is due to cracking of the solder joints ok when cold then fail when hot.
Oil light on in volvos 60
check your oil level ,if ok change the sensor .or do an engine flush then drain and refill and change the oil filter.
Throttle position sensor
With out knowing your engine size, turbo or non turbo, i went with the most popular, most likely choice... its located on your throttle body:
here is what to look for:
<<<<<< new one
I went over a speed bumper very fast,, and the car hit it hard, and my engine went off,,now I can not make work..it cranks but would not start. already look to find the emergency cut off switch, but
When you cycle the ignition to the key on, engine off setting, do you hear a relay cycle for about 3-4 seconds? If so, that should indicate the ECM is firing the fuel pump relay. Most vehicles have a port on the fuel rail for testing fuel pressure. See if fuel is present here by pushing in on the pin in the port test valve. Have you tried disconnecting the negative terminal from the battery for a half an hour to reset the ECM?
Does it have spark? I am surprised that a car company that prides itself on safety, does not have a rollover switch.
CANT GET SHIFTER OUT OF PARK SOMETIMES IT WILL
Hi theres a switch on the brake pedal & a solenoid on the gear shift to stop you moving whilst the car is put into drive if the switch is not working correctly it won't release the solinoid to release the gear shift or the soinoid is faulty or your not pressing the brake down hard enough hope this helps
Not finding what you are looking for?