20 Most Recent 1997 Honda Accord - Page 3 Questions & Answers

You have two problem. The heating and defrost if the blower won't come on problem most likely is either blower motor or control panel. The door locks problem is with the electronic locking system. For some reason the system is getting the unlock command. Try deactaviting the auto lock. Could also be the unlock button on key fob is stuck

your could have a gasket leak on the headers for the exaust.

no such part.

to many possibles if starts and drives after waiting a while fuel pump to faulty sensor ECU should have fault codes stored to read

The headlight switch beads to be replaced. Pretty common problem.

The oil pressure light coming on at idle is not a big worry, so long as it goes out as soon as revs rise.. First step is to remove the oil pressure sender unit and screw in an oil pressure gauge. a mechanic can do this for you. This will tell you if the sender is faulty (common enough) or the oil pressure is low. A rule of thumb is to have about 10 psi per 1000 RPM in the normal rev range If it is indeed low, possible causes are - worn big end or main bearings (the car is old enough) -faulty or weak over-pressure relief valve in oil pump -worn or faulty oil pump -blocked or sludged up oil passages -blocked or sludged up oil pickup strainer mesh in sump Some of these can be investigated by putting the car on a hoist and removing the sump . .

If a B18 is in it, Yes. Otherwise, no

Did you check the track, chain mechanism it runs on? Might need lubricant.

Chilton car care manual

of course changing a brake pedal switch will not help in a reversing light problem they are two totally different circuits check for a damaged wire at the reverse light switch or bulb holder for the reversing bulbs for a dead short as for the rest check the IGN fuse under the bonnet

Try to loosen the item that has the pulley that is out of alignment, and try to tighten the bolts while it is aligned. Spin each pulley to see if the shaft is bent on one of them.

Check that all bolts that originally came with the car are installed, correctly.

You can look in your owners manual for torque specs, it list all torque values for the vehicle.

you do not take the door off of the pins, you will need to unbolt the door hinges from either the jamb or the door.

replace the bulbs they aren't fine

The SRS light means "airbag malfunction" take it to the dealer, only they, will be able to tell you which airbag is malfuntioning. Do not, I repeat do not attempt to fix this on your own airbags have tricky sensor and can cause a even worse problem.