20 Most Recent
1994 Jeep Cherokee Country - Page 7 Questions & Answers
ENGINE STARTS BUT STOPS WHEN
you have a faulty ignition electrical switch. The ignition cylinder has a rod that goes down the steering colunm that connects to this switch
2/14/2010 3:10:44 PM •
1994 Jeep...
•
Answered
on Feb 14, 2010
When attempting to switch from 2-wheel drive to
Your transfer case could be bad, or your front lock hubs need to be locked. Did you switch over while moving or were you static? If switched while moving, you definitely damaged the t/c.
2/3/2010 7:17:17 AM •
1994 Jeep...
•
Answered
on Feb 03, 2010
How to remove ignition cylinder
the details are to long to mention, the best thing to do is go to any auto parts store and buy a haynes manual for your specific vehicle. the books are around 20.00,
1/21/2010 6:02:54 PM •
1994 Jeep...
•
Answered
on Jan 21, 2010
No power to the fuel
You only have power for 3 seconds then it drops to 0v. Did you check with a meter for the 3 second signal when you turn key on, no crank.
Did you spray some brake cleaner or someting into the throttle to see if it will start to confirm it is a fuel issue.
If you have no fuel power and no spark then you have a crank sensor issue..
The ASD relay powers both these systems. If the relay is good and you have no spark or fuel voltge then maybe the crank sensor is bad.
If you have a 3 second pulse and it starts with brake cleaner then you need a pump.
1/12/2010 8:09:32 PM •
1994 Jeep...
•
Answered
on Jan 12, 2010
Tires size on 2001 jeep cherokee
Yes you can go with that tyre size. The only difference between the two is that the 235/75/15 one is broader, which means better balance for the vehicle, which is a good thing.
1/3/2010 7:15:01 AM •
1994 Jeep...
•
Answered
on Jan 03, 2010
Radio -heater-turn signels-wipers-went out at same
Sounds like a fusable link , some of the smaller wires that run from the positive post on the battery have a larger diamiter section about an inch long pull on both sides of these arias together, if it feels spungy then you need to cut out that section, go to the parts store and get another "fusable link" and replace it.
1/1/2010 11:41:24 PM •
1994 Jeep...
•
Answered
on Jan 01, 2010
A belt which is attached to a fan near the front
Not sure what engine you have, but my guess is it's a serpentine style belt that drives everything, including your water pump and power steering, and alternator as well as AC, all in one, that has broke. NO !! do not run the engine at all with that off, or you will ruin it, if damage hasn't been done already. Keep fingers crossed, and get that new belt on before you even put the key in the ignition.
12/24/2009 2:22:50 AM •
1994 Jeep...
•
Answered
on Dec 24, 2009
Where can I find a matrix to change out a
A matrix? How about this: Remove the plastic radiator shroud...does not need to come out as long as it's off the radiator.Remove the electric fan. Remove the upper and lower hose (do the lower first and drain from there) Remove the transmission lines (usually one is a flair fitting and one is a plastic clip) Remove the top bar across the radiator and the hood lock loop. (usually they are torx bolts and you will need the proper bit) Carefully remove the radiator without banging it into anything that will damage the core.
Reverse process to re-install.
12/2/2009 8:10:08 PM •
1994 Jeep...
•
Answered
on Dec 02, 2009
Does the 94 jeep cherokee country have abs
some do, some don't. If you have a simple master cylinder and don't have a bunch of abs components under the hood back near the passenger side firewall, then you have a "normal" system.
12/1/2009 4:35:13 PM •
1994 Jeep...
•
Answered
on Dec 01, 2009
Not finding what you are looking for?