20 Most Recent
1994 Mercury Tracer - Page 7 Questions & Answers
94 tracer problem
not sure about the popping thing, but about the fan, try hot wiring the fan motor to the battery to make sure the motor is not burnt out. could also be a relay or a fuse link. I'm working on a 95 and having trouble locating the fuse links. I replaced my radiator fan motor, thermostat was busted, dropped new fuses in and a relay. Still no fan action. Mine must be a fuse link. If you are lucky it will be something quick to diagnos. Good luck.
How to reset fuel cut
si a tenido choques o golpes fuertes en la parte frontal del vehiculo o atras debe haberse activado el sensor de impacto, esto causa que deje de enviar combustible al motor por razones de seguridad. tambien debe checarse los fusibles que indiquen fuel que este en perfectas condiciones
Door Panels
There's a small wire clip right behind where the door panel meets with the crank. Its really hard to see. I had to pry the crank a bit with a screw driver to see it. Anyway, when you do see it there's a part that protrudes more than the rest, and you can slide a screw driver back there and pry it out.
Replace heat,sensor 92 1.9 merc tracer
What are your symptoms 1) No temp reading on dash gage...2) Staying at high idle (open loop ECU)....3) No cooling fan operation......Do not run this engine Hot...Blown Head gasket hazard exist.............
How do I remove the cigarette lighter in my Tracer. It is really hard to reach the back of it.
I don't know what year it is. But this video from youtube may give you an idea of how to do yours. You can buy electrical tape & a cheap screwdriver & needle nose pliers at Walmart. Wrap the screwdriver tip so you don't scratch your plastic like this guy did in the video. Use the needle nose to unscrew the nut, if there is one. The replacement lighters show just a Blade type; 1-prong male terminal. Have you tried just prying it out near the rim of the lighter? https://www.youtube.com/watch?v=CmwXCBo2M9k&list=TL22RiG_zP4oVIBeL9_yKdcKytU23ZZ3o0
2000 mercury tracer battery light staying on with new altenator ..why?
The battery is most likely controlled by the PCM computer, so you need to perform a fault code test to see if any faults are present in the charging system. If this is a cheap rebuilt you also may just have a defective one, I went through 4 to get a good one from Autozone once, never again I guy OEM parts only now.
1993 Mercury Tracer backup lights
Go to autozone.com and register for free. Registration will give you access to manuals for your car, one of which will have a diagram of the fuse panel with an explanation of each fuse.
1996 mercury tracer 1.9 no fire no fuel
Check your ground to the frame, it is an easy thing to check.
Possible bad fusable link. If the main fuse burns out, nothing will work, not the fuel pump and not the ignition system.
1993 Mercury Tracer overheating after running 15 miles or so
possibly air trapped on engine side of thermostat-possibly. HOW TO BLEED: loosen coolant temp sensor. Start engine. As engine warms, slightly unscrew sensor to allow air to escape. Once a steady stream of coolant trickles out you're good. Let us know if this helps. Good luck.
1993 Mercury Tracer coolant bleeder
Never seen this or even heard of it so a lot of good i am here but i dont think it has one so fill it up run engine with the rad cap for a minute or two ,fill up to top and run engine till fan comes on then allow it to go cold overnight and then refill this should do it ,use min of 50% antifreeze regardless to prevent corrosion in the engine more if your in ice road truckers area
How do you know if an injector is bad and how can you test it
There is a tester called a Noide light. This plugs into each injector wiring socket to see if the injector is getting a pulse. You can accomplish this same thing with a Voltmeter. Sometimes the auto parts store have loaners in Noide light kits.
But this will only show you if power is going to the injector. You need to do an Ohmmeter for continuity on each injector. This will give you a fair idea if they are passing fuel.
You will be able to tell if injectors are getting their pulse using the noide light.
Not finding what you are looking for?