20 Most Recent 2005 Jeep Wrangler Questions & Answers

it could be your brakes , on most brakes there is a wear tab that makes a high pitched squeeling noise when it contacts the rotor. this is in place to let you know your brakes are due for replacement. if it is not your brakes then it could be a wheel bearing.

change your spark plugs if they haven't been changed in awhile. check your tires for the propper psi there should be a sticker on the inside of your drivers door that will tell you recomended air pressures go by this not the recomendations on the tires. also where are you getting you gas does it contain ethanol sometimes this can burn faster.

Thank you for taking the time to respond.

You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams, error/fault codes, torque specs, PCV, owner's/service/repair/parts/maintenance manuals etc everything this website www.reliable-store.com it's a very good website for vehicle problems even as old as 1991 ford..

Blower resistor is bad . Do you know what that is ? Jeep Cherokee Blower Motor Resistor Replacement

Have you checked the clutch master cylinder fluid level?

its bad,the PDC no country stated, no engine stated,? why? the 2005 (answering for USA) PDC hard short all fuses, all breakers all relay out means what? well power distribution2 below shows all that, every wire there. ASD relay pulled? you never said relays, they can (weld closed inside contacts can)) and is unfused, this relay. fact i read the 22 pages for you there, its just fuses and relays, no magic until 2007 (TIPM electronics) this car is easy fix,. due to 2005 year. looking now , TJ unlimited it is. see the manual yet, see how this all works 2003 to 2006 year. chapter 8w shows wiring, and modules the rules. 8w, pdc 2, chapter see that here, its there, clear as day.' http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

to check maf or 02 sensors plugs ,coil, timing fuel delivery to injectors

huh? did you read manual yet. open glove box, read pages in oper, guide on top yet>

I have an 05 6 cylinder automatic TJ. The other morning I was getting trouble codes U0101 and P1603. For a few seconds the Jeep was shaking and for the entire 30min ride it wouldn't shift into the last gear, it would just continue to rev. The next day I drove it and it was fine. I also noticed a slight high pitch whine noise coming from the engine at low speeds. Any suggestions? Thanks!

check adjustment on shifter arms under on transfercase

What part?

Ask parts store to run the codes (usually for free).

disconnect battery for ten min

pull out spark plugs and see if they all look the same,could be dirty fuel injectors or a blocked fuel filter

Sounds like the synchro mesh has worn out

so its just the light bothering you, (i ignore mine) I can tell car is in 4wd or not, dont need no stinkn light, so.... is it in 4wd or not? we cant guess that. only you.. the light is hard wired to the transfer case switch if the switch closes, you are in 4wd, or the switch is bad. end story on silly light. and fuse 10 is the power for that light. on this car , there is no computer running this light, im driving on what.? dirt, ice, dry pavement what? my guess, wild. is car is in 4wd. and you are not on ice or dirt and its stuck, Part time 4wd is for dirt or ice only and will stick. drive to dirt, or jack up 1 wheel and shift in to 2H. fixed now? light out? answering for PT 4wd . not came new with NV231 or 241 and both are part time 4wd, now AWD. ever read this. http://www.rubicon-trail.com/4WD101/driveline-bind.html dont do that, posted 100s of time here.