20 Most Recent
2002 Acura MDX - Page 8 Questions & Answers
Changed oil in my 2004acura
Hi.
Check the oil filter, and check the oil pan for cracks.
Clean the engine and oil pan, so that you can find out if there is a leak.
I need radio code 2002 acura mdx
If that is the serial # of the radio any Aucra dealer can provide the radio code. You can also sign up at the Acura website under owner's section and get the code.
Front rotors replacement
Take off wheels..
Take off calipers..
Take off center nut..
Pull rortor off..
Replace..
Hope this helps !!
rate me good ;o)
My 2002 MDX continues to pull strongly to the
If you paid for a four wheel alignment. Did you ask them why it is still pulling to the right? If everything is balanced and aligned then it should not pull to the right. It sounds like they are missing something. Have you checked the tire pressure? If its not up to proper inflation or if there is enough of a difference this can cause it. Also a dragging brake caliper can cause this as well. Hope these suggestions help, let me know if you have any other questions.
Thank you,
Lee
02 sensor heater circuit code
replace O2 sensor the sensor is not preheating to the appropriate temp in time for cold start lean out
(it will use more gas upon start ups)
04 MDX. just had
Hi,
Regarding Rough Idle, that might be due to misfire.
a tight valve would set random miss fire codes
and cause a rough idle but since this just started after the timing
belt replacment it leads me to that area first. but if your 100%
positive then you can look at the valves but the fuel trim is lean on
both lt and st which i have seen this same condition and has been
resulted to belt timing.
Check and let me know.
Thanks for using "Fixya".
CABIN AIR FILTER?
its a pain but can be done. It is located in the housing next to the evaporator under the right side of the instrument panel.
If it is the first time being replaced there may be a plastic cross brace in your way that you will have to cut.
Remove the glove box frame.
At the top you will find a tab that once you release you should be able to remove the filter door and access the cabin filter.
P0108
the code is for the MAP sensor manifold absolute pressure. This sensor can cause serious driveabilty problems .There are 2 different types used on cars and there are ways for a shop to test them with a volt meter and hand help vacuum pump. or you can just replace it see if it corrects your problem and ask the place you buy it from if it doesnt can you return it .and then let a shop diagnos the problem .
Speedometer and Cruise control dont work
It sounds like the computer system is still wet. I would wait a few more days before I panic and hope that it drys out. I don't think it's a fuse.
If you have to have the onboard computer replaced, it can run a couple of hundred dollars.
If you have the engine cleaned again, make sure that the electrical systems are protected well otherwise getting them wet will repeat your problems.
Not finding what you are looking for?