Top 20
2006 Hyundai Tiburon Questions & Answers
Can I use synthetic oil in 06 Tiburon?
Check with the application catalogue of your choice of oil brand and you should find your car listed with the appropriate grade of synthetic oil.
There is a note of caution, especially with an engine that has already covered a fair mileage. Depending on the service history and the type of oil used in the past, the engine could be clean, slightly dirty or very dirty inside and changing to a high detergent oil if the engine is dirty could cause problems. Detergent oils scour the inside and cleans things and holds the dirt in suspension so it gets drained at the next oil change.
The trouble is, there is a limit to how much dirt the oil can hold and if that limit is reached mass dumping can happen - blocking filters and oilways.
It is a while since I encountered an engine that died of a thrombosis and the additive packs of oils have been improving all the time but the point should be considered...
WHERE IS THE BANK 1 SENSOR 2 LOCATED?
If you mean O2 sensor, bank 1 is the driver's side on RWD, or front bank on FWD. The #2 sensor is the one behind the catalytic converter, which does little but telling the ECU if the converter is doing its job.
How do I get my alarm system to chirp instead of beep when it goes off or when I lock my doors with the remote entry key fob?
Check to see if your vehicle honks when you press the "lock" button on your key fob. Press the "lock" button multiple times in a row. Many devices won't beep unless you double-tap the button after locking. If the horn doesn't honk, but the lights flash, your chirp feature is probably disabled.
Use your keyless fob and ignition key to enable the audible chirp. The process varies considerably on different makes and models. You must usually consult your owner's manual, a dealership or the alarm manufacturer for the correct process.
Misfire at all speeds
Do you smell gas when your outside the car? Say hood lifted and a strong smell of Gasoline?
How to reset the catalytic converter and 02 sensor?
No such thing as resetting those sensors
If the Oxygen Sensors work, the check light on the
dash will go out when the Emissions Monitors Run
for that system
You have 8 I/M Monitors that have to run clear before
you can go to inspection
Have a shop road test with scan tool to check that & make
the required repairs
Code po1082003 elantra
this is the MAP sensor , it may need replacing but there are a couple of things to check before changing the sensor, 1. check all vacuum pipe's for signs of wear etc 2.have the MAP sensor further diagnosed for faulty wiring 3.might just need a clean with some solvent spray cleaner ie brake cleaner
Will not start but turns over
need more info did car not start like flooded before battery went dead might need to ch ange plugs there probably all wet
2004 sub will turn over but will not fire
Use a bottle of yellow HEET dry gas to remove any moisture problem in the fuel.
Clean / replace air filter.
Check ATF at level ground. Top off ATF to MAX level.
Use starting fluid to aid starting.
Will not start
use a code reader to reset the CPU as the program may be corrupted.
Not finding what you are looking for?