20 Most Recent
1997 Infiniti.5 Q45 - Page 4 Questions & Answers
Does a starter come out the top of a 2000 infinity
bottom, but the manual mentions a couple different procedures. See below.
4.1L Engine
-
Before servicing the vehicle, refer to the Precautions section.
-
Remove or disconnect the following:
Negative battery cable
Steering gear and linkage assembly
Harness connector
Starter retainers
Starter
To install:
Install or connect the following:
Starter
Starter retainers. Tighten the starter retainers to 30-37 ft. lbs. (40-50 Nm).
Harness connector
Steering gear and linkage assembly
Negative battery cable
Alternate procedure:
-
Remove or disconnect the following:
Negative battery cable
Engine undercover
Harness connectors
Starter motor mounting bolt and nut
-
Remove engine mounting insulator bottom nuts, and lift engine approximately 2 inches with a transmission jack
-
Remove starter motor
To install:
-
Installation is in reverse order of removal; observe torque values shown in diagram
Fig. Starter motor mounting and torque specifications-Q45 & 2004 M45
Will sometimes stall at stops, feels like its
First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM.
Let me know please about found DTC's. I will assist you kindly to fix the problem.
1997 Q45 INFINITY, TROUBLE CODE U3FFF, TCS off
i am not sure were or how you got that code. there are no trouble codes starting with a U or ending with any letter all engine performance codes will start with a P and then 4 numbers all ABS/TCS codes will be only 2 numbers and cant be retrieved with a code reader they must be retrieved by means of a test procedure i can get the procedure for you if you want it i will need your e-mail to send it to because fixya does not have enough space to post it on there sight.
When turning over the ignition there is no
HI! its the solenoid on the side of your starter motor ,this 'part' makes your starter cog push out onto the engine flywheel to crank the engine over ,they get tired as they age and the easiest way to fix it is to get a new starter motor or find a second hand one from a auto wrecker that gives a 3 month warranty with it,they are sometimes very awkward to remove and i suggest having it removed by a auto-electrician or mechanic and give them the replacement to refit ,this is most definitly your vehicles problem.
THANKS FOR USING FixYa
Check engine light stays on
abs
You need to take it to a shop and let them hook the computer up to it and tell you what the codes it is showing and another way to keep you from paying alot to have that done is to take your battery terminal off for 15 min. and that will reset the computer.
My 1994 q45 ran out
sounds like you may have clogged the fuel filter due to debris on bottem of tank or burned out your fuel pump , Id try spraying starting fluid in the air filter duct and see if it starts then , if so you found your problem via above!!!!
Where can i find the knock sensor on a 1995
The knock sensor on this vehicle is in a hard-to-get place between the engine and the firewall. I had to remove five or six coolant hoses and a metal cooling pipe that is bolted behind the engine in order to change the stupid knock sensor. Total time was about 15 hours and several trips to the parts store.
Not finding what you are looking for?