Top 10 2000 Lincoln LS Questions & Answers

1. hold gas pedal to floor while trying to start. do not pump pedal.
2. holding pedal to floor is how you start a flooded f.i. engine

- If temp guage reads normal, the lack of heat may be due to the Heater Control Valve. Located in front of the radiator. Lower passenger side. A real bugger to replace.
- The plastic cap just over the thermostat is key in re-filling the anti freeze and bleeding air.

It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.

Hello okiecouple, my name is JShreader. Thank you for choosing fixya.com

There is no "Dip Stick" on this Transmission. Instead, there is a Drain/Fill/Check Hole on the bottom back side corner of the Transmission. Below is a picture of it...

On these Lincoln Transmissions, for proper test results you need the vehicle sitting perfectly flat (in the shop, we have equipment to ensure the vehicle is perfectly level). I went ahead and made you up the Transmission Fluid Checking Procedure in .pdf format. You can download it by clicking HERE. I hope this helps you. If you have any more questions or need any more diagrams, please don't hesisitate to ask...Thanks again, JShreader.

License Plate Lights Removal & Installation License plate lamp retainer clips

To Remove:
Remove or disconnect the following:

1. License plate
2. Pin-type retainers and the luggage compartment lid trim panel
3. License plate lamp electrical connector
4. Lamp socket from the license plate lamp
5. Using a suitable tool, through the access hole, release the clips and remove the license plate lamp

1. Install or connect the following:
2. License plate lamp
3. Lamp socket to the license plate lamp
4. Electrical connector
5. Luggage compartment lid trim panel
6. License plate

HI. Here are a few details about this remarkable sensor and its functions.

This sensor monitors the temperature of the engine and sends that information to the engine control computer to regulate the amount of fuel needed. More fuel is needed if the engine is cold; less if it's hot. If the temperature is extreme, the signal will be sent to the temperature gauge as a visual indicator of overheating and imminent danger. The location of this device(Cylinder Head Temperature Sensor) will be on the passenger side of the cylinder head, under the third intake port from the front in the valley of the engine. White/violet, and brown/white will be the colors of the(2) wires that connect to the sensor.

• NOTE: Be sure to purge the coolant system before replacing this sensor.

The actuator is on top of the heater box behind the glovebox area

You really have 3 panels with fuses in them so I went on and gave you all 3 of them. This should be in your owners manual if you have one. If you do not and would like a copy, you can email me at [email protected] with your make, model & year and I will be happy to email you a copy. Don't worry, no cost to you. I hope this helps and good luck.

Try turn the key in the drivers door three times or check this procedure in your Owners Manual.

You are comment that change ECM? If this is right, will need visit your dealer to reprogram and resynchronized the security module with the new ECM.

Hope helps.

The FOAB-14B192-AA controls the fuel pump and other electronic accersories. It ensures that the primary voltage of the battery is fully used and manages one or more different voltages.