1996 Land Rover Discovery - Page 8 - Answered Questions & Fixed issues
Land rover rear axle
The pinion bearing preload should be 3 Nm on a pull scale with the side shafts removed.
Rover 214
Check the ignition module next to the coil , this is normally the culprit
Car radio problem
We left the radio on for an hour and it reset itself back to "code in". We then entered the correct code and it works perfectly
Fitting a new fan belt
Remove the fan shroud cover and draw the fan belts route, loosen the aircon tensioner bolts x 3 on the left side of the cover and remove the aircon belt.With a 15 mm socket on a power wrench pull the auto tensioner to the rightand remove the belt , with a little skill and patience you can get the old belt off and the new one on over the fan blades without removing the fan.Make sure the belt is on properly to prevent it coming off when starting.
I get a gas odor in the interior of my 1996 land rover discovery
The gas smell is from your tail door seal,the window that is open causes a vacuum from this area , adjust the door to close tighter or replace the seal.V8 idling problem ,remove and clean the idle control valve situated on the rhs rear of the intake manifold (seen from the drivers seat )adjust the idling on the allen key screw near to the throttle cable lincage.
Need Radio Code
Hi aawren
In the front of your owners manual you will find the company that originally sold the car.
Ring them and provide them with your V/N number and they will provide you with the code, write it down for when ever you disconect the battery to save yourself this problem again.
Failing this in the event that you cant find your owners manual, ring Land Rover Australia direct and follow the same procedure as above.
Hope this helps!
Teamstear
Brakes
they are just Disc brakes,, no special deal,,,,
Windows
Hi.
I had this problem on my discovery 300 tdi, behind the gove box is a black box bolted onto the small bulkhead if you open this, you will find a circuit board with 2 plugs going into it, this is the ecu for the windows you will find that there will be a dry soldier joint on the circuit board just check this, my discovery had the same problem, re-soldiered the circuit board and all works fine.
If you google for landrover forums you will find the answer on there.
hope this helps.
Engine no start
the fuel filter located: under passenger side nr back wheel
Sat nav stopped working discovery sport 2015
You can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
3/19/2019 9:41:26 AM •
Land Rover...
•
Answered
on Mar 19, 2019
•
267 views
Replacing bonnet release cable on a discovery 2 td5
you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
3/19/2019 9:24:29 AM •
Land Rover...
•
Answered
on Mar 19, 2019
•
177 views
Discovery 3 transmission fault limited gears auailable as come up on the dash
There is a procedure for emergency EPB release, which is worth a try to make it go temporarily;
Turn off engine.
Select P if auto, apply foot brake.
Push and hold EPB switch/lever down.
Turn ignition on, wait for system check to cycle.
Start engine.
Release EPB switch/lever.
The EPB should have now released
1/27/2019 9:36:17 PM •
Land Rover...
•
Answered
on Jan 27, 2019
•
1,206 views
Not finding what you are looking for?