Top 20
1999 Land Rover Discovery Questions & Answers
1999 Land Rover Disco. I added power steering
Why did you add fluid - check the cap is on and that the hoses don't have a split otherwise it would help where the oil is in the engine bay if it's the front there is a leak hitting the fan likely coming off the pump onto the serpentine belt
99 land rover disco overheating!
Start with the cheapest part and that would be the thermostat. They are easy to replace and that appears to be the issue. They do wear out or stick.
Where is the fuel pump on a 1999 landrover discovery sd
look for power at the fuel pump connector at the fuel pump in the fuel tank (the wire that should have power when the engine is running or cranking over is White and Purple (maybe White and Pink, I can't remember). These cars also have a fuel pump inertia switch (a crash protection device, if it fails the fuel pump looses power), located passenger side rear of the engine compartment, same type used on Jaguars seen the fail, just press the button on top of the inertia switch to reset it or temporarily bridge the two wires and see if the engine now starts. Fuel pump relay is behind the right front kick panel at passenger right foot well.
Service engine is on
You need to retreive the diagnostic codes to determine the reason the light is on.
1999 Land rover discovery
New battery
Need to
call it a lesson well learned ,it's called a memory saver , a 9volt battery that plugs into lighter , power port saving your cars memory if you do it again (changing or disconnecting battery) now you need to take a trip to dealer to un lock radio .
Where is the ecu located
i think their are 2 of them behind the glove box and under neath the dash on the right hand side (unless usa or aussie cars have 1 under the passenger seat )
How to replace drivers side actuator on 03 land rover discovery
Unhook battery
Remove door card torx and Phillips needed
the window frame needs to come out to get clearance
remove the lock bolts in side of door (torx very tight) unplug the loom from the lock and unhook the rod from the inside pull handle
once done the actuator comes out leaving the lock barrel clipped to the door - replace in reverse expecting it to take a while and don't break the plastic clips holding in the actuator rods or they will fall out down the line...
Not finding what you are looking for?