1992 Saturn SL1 - Page 6 - Answered Questions & Fixed issues
How to replace 1997 ignition switch Saturn SL1
Buy replacement switch first because you going to be working under the dashboard in an upside down position. Disconnect battery. This is important. Next crawl under dashboard so you can see or feel wires from ignition switch, remove them slowly and one at a time. Switch comes out after the clip in the back is removed. Now that you have it out, Take the new one and put it in with clip, follow other steps in reverse. A local repair shop will do the job for a small but worth while charge
WHY IS MY 1999 SATURN SL1 NOT KEEPING A CHARGE?
probly no unless u contaminated one causin a bad connection-chec them all again-the fan cud be old or the fuse looks good but really bad--the clickins from a bad battery or alternator--1st tightrn the the cables on both-then do a testdrive--if nothn then get them tested at a privateshop
I have a saturn sl car its a 2002 and it doesnt have no spark to the plugs
check that there is power to the coil with the ignition in the run position. I suspect that there is a failure to communicate between the key and the immobiliser in which case there would be no fault code as the code would only be reported if the fault was in the car system. Check the battery in the key.
Why is the coolant overflowing when the temp guage gets half way?
well the tank must never be full, when engine is cold
was it? (read operators guide to see methods)
water expands hot, and the tank captures this expansion
that is normal.
what does "until its all gone", mean, what is IT?
there are lots of tests.
the first one, is,
IS the engine overheating,?
try a new rad cap, they are dirt cheap.
and, is the oil or carbon in the RAD neck, cap off , cold engine>?
is there water in the engine oil, milky dip stick end?
same with A/T trans? milk, or pink/red ATF.
is there steam going out the tip of the exhaust pipe on a fully hot engine>? yes/no?
is air and water exploding in to the side expansion tank.?
cold engine
remove rad cap'
fill rad with 50% AF.
new cap back on.
put 50% AF 1/2 way up in to expansion tank(its marked clearly)
start engine , does it overflow now>?
What is wrong with a saturn sl1 indicator says it is hot after running for 5 minutes
John sounds like your sensor may be bad. Next it could be your thermostat sticking use a temp gun and measure the temp of your radiator at the cap. Do not remove cap. Just take temp. If it is getting hot it should spit water out. Check to see if the electric fan is coming on the sensor to cut the fan on maybe bad or the fan. Hope this helps.
Not finding what you are looking for?