20 Most Recent
2000 Hyundai Accent - Page 3 Questions & Answers
How do i replace the front wheel studs on my hyundai accent
Hyundai in all their wisdom decided to use captive dust shields on the disc brakes. You need to completely disassemble the hub to get the shield off. On my 2008 Accent there is one spot that if you rotate the rotor to that spot and bend the shield back you can then get the stud in place. Be sure to get the right stud as the rear and front are probably different part numbers.
To get the old out use a hammer and a punch to pound them out the back. To get a new one in push it in as far as you can, then using something as a spacer (large nut or washers) and the wheel lug, tighten the stud up drawing it into the rotor.
Hyundai Accent SI-back windscreen wiper
there is a 15 amp fuse for the rear wiper under the bonnet check this, also i think the accent has a seperste switch in the dashboard for the rear wiper like th hyundai coupe.
Replacement clutch is too small? Thought there was only one engine in 2000 hyundai accent, the 1.5L. Title says its been rebuilt twice. How do I find out what clutch i need to ask for?
the different clutch sizes are for the different capacity engines
The 7" would be most likely be for the 1.4 or 1.6 version engines where the 8" would be for the for the 2.0 or 2.4l engines
If the flywheel is flat across the face ( not recessed) the the clutch plate you want will fit as long as the pressure plate is the same diameter and the bolts fit the cover to the flywheel
it is possible to get a standard clutch kit or a heavy duty clutch kit which has a higher pressure plate reading to cope with heavier loads ( towing etc)
if an 8" came out , you need to replace it with an 8"
The bigger the clutch , the longer the period before replacing it
If you can get to it you can measure the shiny wear patterns on the flywheel and if the incorrect plate was fitted at some time you will see the old wear pattern outside the latest shiny surface
what you have to be aware of is the spline number and size of the new clutch plate so try it on the input shaft before fitting to the flywheel
Battery will not stay charge inless radio and heat is on
would need a little more clarity on what you mean by stay charged. However if you mean that the battery runs down and dies after a period of time with the radio and heat on, then I would go to a car parts place like auto zone, oreilys, or advanced auto parts. They will be able to test your battery and your alternator. It could be that your battery is weak and needs to be replaced, or that your alternator is not charging your battery fast enough. Hope this helped.
Hi, My GETZ dashboard has become very sticky, how
Hi. I am having a Getz GLS and faced similar problem I looked for a solution and at last got it resolved myself and that too PERMANENTLY. IF you want to check out, them mail me to
[email protected]. Now my car dash board is absolutely normal. Stickiness gone for ever. If you are in Kolkata, I can also show you my car.
Pwr failure somewhere when starting CAR....
trace the wire from the ignition switch start position to the starter solenoid the wire may have fallen off the starter solenoid , have a loose connection or be corroded or may have a fuse in the circuit that has blown
It keeps popping out of fifth gear
sounds like a 5th gear synchronizer is going out you might have to have your transmission rebuilt hate being the bearer of bad news but that's what it sounds like hope this helps
Not finding what you are looking for?