20 Most Recent Hyundai Motor 2004 Accent Questions & Answers

no inertia switch

It can be broken baring wheel on waterpump,you can change pupm, belts tensioners. Or it can be hidro valve- which engine oil do you use. Use not 5w30-its too thin ,better use 5w40 or 10w40. Zoran Vrgec, Osijek, Croatia

What are the fault codes you have? Is the check engine light blinking while driving?

Throttle position sensor could be the problem
Emmission control parts
You mentioned idler cable
Well there may be a second idler control cable
Some vehicles come with a double cable adjustment
The second adjustment is right above the gas pedal
Turning screw
Alternator giving out not producing charge needed
But overall if your cars idle bogs down the likely culprit is your ac bout to go out
The bearings in compressor wear out so it pulls more on the engine
In turn bringing rpm's down
Your car needs routine maintenance
Ac is an expensive repair so i suggest bypass belt till you can pay to have it fixed

ive got a 1994 1.3 accent and now its spluttering was does it mean ?

If it's manual transmission then bump start it. You may find that simply putting it in gear and pushing it a little will wake the starter up.

Now you have to start the wiring from the motherboard to have the wiring run correct. Easy fix. Junkyard should have a light for your car.

Check your solenoid

if it has one, the timing belt should be done, along with a tune up. spark plugs air filter, fuel filter. etc

take it to auto zone and have the fault codes read for free come back with the revealed faults

Starter motor.

That sounds like a timing/ cooling system issue. The coolant sensor would adjust the timing etc. Your tech would have to scan the car & check the live readings (HOT & COLD) & check the emissions. Put all the pieces together & solve the puzzle

Do you have a check engine light on? If not there is no problem in the system.

Does the motor crank (starter engaged and turning the motor)? If it does not crank, do you hear the solenoid clicking (engaging the starter gear into the flywheel teeth)?

should be in the owners manual http://justgivemethedamnmanual.com/hyundai/2004-hyundai-accent-owners-manual