20 Most Recent 2006 Lincoln Town Car Questions & Answers

Check the fuse and brake switch a better answer would pull the bulb out and check sockets

yes they have radio codes

there are 3 screws and a little tab to push down after you take screw out push tab down and remove hold assembly

it is the one with the black plastic cap nearest the fire wall passenger side next to the dryer just clip on a/c charger kit go to about 45 lbs r134a the 2 ports are different sizzes anyway

It is located on the lower part of the car seats the part where you legs go griver is on the right of seat passenger is on the lft lower part of the seat

The push button on/ off switch is n/g

It's old question, you might find it out already. If not, here is pictures and diagrams. It might be two different routing. Mine is limo which has two alternators. try to see which is yours. (red was mine with two alternators. original is black in diagram) also you may know how to loosen serpentine by insert and turn 3/8 drive ratchet (just ratchet without any socket) to tensioner pulley if not, here is picture (I use 3/8 ratchet + pipe).Picture was taken after 2nd alternator removed (around upper hose)

Here you go...

It could be your battery is getting weak or has a bad cell or two. This will cause all sort of weird things to happen with these computer controlled cars.

Since you just changed the brake switch at the base of the brake, I would look first at the plug connection and then at the setting for the plunger that gets depressed when the brake is applied. It seems to me that if the brake is even touching the plunger that it may activate a false braking condition which deactivates the cruise control. Hope this helps. Bill

I had brought 2006 with similar problem to a mechanic he spend couple hours and think it may be lighting relay but he is not positive!. Since he could not fix the problem did not charge me. I had offered to pay for their time!

Even after bulb change, do all lamps work? Bad ground can be shown by weak or dim bulb sometimes and this can cause fast flashing. All bulbs which flash must be working and of normal brightness which is sometimes hard to tell when they blink really fast.

Check your air intake sensor or 02 bank 1and 2 sensors

Some makes and models, if battery voltage is lost, the radio may go into theft lock? If that is the case, your local dealership may have to fix? Look at your owners manual, see if it says anything about radio theft lock? The wiring info I looked at was for radio w/o navigation, note the fuses.

I've done it so many times for exact 2006 TC. 1. Remove black plastic cover if it's equipped by twisting 5 fashioners. Those are looked like screws but plastic fashioners. 2. Remove 3 screws (two on top one on bottom) Do not touch adjuster screw. 3. push down plastic hook between two top screws and pull whole assy. be careful not to make scratch on bumper. Remove wire connector before you pull it out completely. 4. After you remove assy, take 6~8 screws on back cover, then you will see light valves.I have problem to upload pictures now.I will upload them as comment to myself.

Code 354 is for a problem with the control circuit for coil #4. It could be the coil, or the wiring to the engine computer, or the computer itself. The coil would be tested first by switching it with another cylinder if possible.

Check the fuse on the bk of the radio.... if it is an after market.... as for the window get a tester and check to see if there is power going to the window... cause it Sounds like a bad fuse... maybe one that doesn't look burned out but is

You have to fix the problem with the air bag and clear the problem code. Have someone scan it with a scanner.

you need to take it to a front end specialist so they can see if the frame is out of alignment or it may need to be aligned it could be a rack & pinion unit get it checked it sounds dangerous .