20 Most Recent 2006 Fiat Strada Questions & Answers

0helpful
3answers

Have a fiat strada bakkie in the mornings it

check your fuel pump pressure, and fuel rail pressure
11/17/2023 12:14:05 PM • 2006 Fiat Strada • Answered on Nov 17, 2023
0helpful
2answers

Fiat Strada

Bad transmission.
6/29/2019 6:50:02 PM • 2006 Fiat Strada • Answered on Jun 29, 2019
0helpful
1answer

Hooter does not work in Fiat Palio

heater tap ma be siezed or blocked
or its control cable loose or broken
2/11/2019 1:00:06 PM • 2006 Fiat Strada • Answered on Feb 11, 2019
0helpful
1answer

Leaking water cooling system - drips when cold

Put head gasket fix to coolant good one it is working I did a few times.
5/15/2017 1:16:46 AM • 2006 Fiat Strada • Answered on May 15, 2017
0helpful
1answer

Which fuse is it for indicators on fiat punto

1998 on an R reg
11/15/2016 4:46:05 AM • 2006 Fiat Strada • Answered on Nov 15, 2016
0helpful
2answers

Dashboard warning light

Check your mass air sensor MAS it may need cleaned or changed
8/11/2016 7:22:45 AM • 2006 Fiat Strada • Answered on Aug 11, 2016
0helpful
1answer

I have a Fiat Strada 1.2 el bakkie. When starting the vehicle it swings but does not start. Can you advise what the possible issue

cam/crank position sensors immobilizer issues ignition control module injectors nor working low fuel/ no fuel pressure run the fault codes to determine which of those need fixing
6/10/2016 5:56:53 AM • 2006 Fiat Strada • Answered on Jun 10, 2016
0helpful
1answer

FIAT PUNTO 1.4 FUSE BOX

On this website (link below you find fuse box diagram and description for: Fiat Punto mk2 Fiat Punto mk2 Classic from 2004 fuse box diagram Auto Genius Fiat Strada FL Fiat Strada mk4 FL from 2011 fusebox diagram Auto Genius
3/29/2016 9:55:32 AM • 2006 Fiat Strada • Answered on Mar 29, 2016
0helpful
1answer

Do you have a diagram of a Fiat scudo 1.9d van

On this website you find fuse box diagram and description for Fiat Scudo mk2 Fiat Scudo mk2 2006 2016 fuse box diagram Auto Genius
3/20/2016 11:30:49 AM • 2006 Fiat Strada • Answered on Mar 20, 2016
0helpful
1answer

Fiat multipla 1.6 petrol revs up on its own

sounds like a bad motor mount
12/29/2015 1:13:49 PM • 2006 Fiat Strada • Answered on Dec 29, 2015
0helpful
1answer

New windscreen has cracked on fitting

More details, please.
2/20/2015 8:48:19 PM • 2006 Fiat Strada • Answered on Feb 20, 2015
0helpful
2answers

Fuse for the cigarette lighter

First off, make sure if you are replacing the fuse yourself, take the keys OUT of the ignition and put them in your pocket!

I'm not 100% sure, but there should be a fuse box under the hood on the driver's side. In the lid of the box after you remove it (or on a label on the top of the box) is usually a diagram showing the location and function of all the fuses in that box. I think it's listed in the manual as being fuse spot F54. If my sources are correct it should be a 20amp (yellow) fuse but always check the recommended fuse replacement by the diagram or in your owner's manual.

A helpful tool to buy from an auto parts store or auto parts section of a wal mart or k-mart, is an automotive fuse puller with extra replacement fuses for your car. If you're unsure of what fuse is the right one, take the old fuse out carefully with needle-nose pliers and take it to the store to compare. If you take out the right fuse, driving with out it should not harm your car in any way (it's broken already).

I hope I could help you find the right fuse box for the cigarette lighter. Good luck, and don't forget to rate! Thank you.
7/21/2014 4:35:08 PM • 2006 Fiat Strada • Answered on Jul 21, 2014
0helpful
1answer

How to remove a broken window mechanism in a Fiat Strata Bakkie

To get to a window mechanism, the inside panel has to be removed. Locate all screws that hold the panel handle and any other part of the panel to the door frame. The sides and bottom of the panel are held in place by panel retainers , which pop out of the door frame. Place a panel tool or flat screw driver along the sides and bottom to pop out the retainers. Once the sides and bottom are free t, the top of the panel should lift up out the track on top. Be careful of any wiring before you remove the panel.
6/11/2014 11:14:37 AM • 2006 Fiat Strada • Answered on Jun 11, 2014
0helpful
1answer

Taming daigraph of fiat strata 1.6 16v

#1 piston must be on the compression stroke top dead center
5/3/2014 10:56:43 AM • 2006 Fiat Strada • Answered on May 03, 2014
Not finding what you are looking for?
Cars & Trucks Logo

245 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Fiat Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Any Car Diagnostic...

Level 2 Expert

274 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Fiat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Strada Fiat

  • Strada Fiat

Most Popular Question

fiat strada 1 2 el bakkie when starting

  • Cars & Trucks
Loading...