2007 Toyota... | Answered on Jun 26, 2019
2007 Toyota... | Answered on Feb 15, 2019
2007 Toyota... | Answered on Feb 13, 2019
2007 Toyota... | Answered on Feb 27, 2018
2007 Toyota... | Answered on Feb 23, 2018
2007 Toyota... | Answered on Sep 20, 2017
2007 Toyota... | Answered on Feb 18, 2017
2007 Toyota... | Answered on Feb 10, 2017
This code indicates the secondary air injection pump may not be working correctly. The pump is located on the front passenger side wheel well. Turn the front wheels sharply to the right and remove the plastic cover on the wheel well. Don't waste time trying to preserve the plastic clips. It takes a special tool to remove them and it is easier to purchase new clips at Auto Zone for $3.99 a pack.
The pump is bolted on using three 12mm bolts. Remove the inlet tube and exhaust hose from the pump. The pump is wiring is connected directly to the motor with a two foot extension. The cable is feed through the same hole the outlet tube is in the fender well. It is terminated into a simply connector located on the front passenger side of the engine.
Remove the motor from inside the fender well. Remove the bolt located in the center of the plastic cover. Remove the bolts located on the corners of the housing. Inspect the blower for wear and moisture. Clean as necessary. Attach an extension wire to your battery. Please use caution before attaching them to the fan wires. The fan spine at high RPM's and it may startle you at first. Obviously if the fan turns it works move forward. If it doesn't there may be binding, carrions, or the motor is burned out. Inspect and repair. The worst case scenario is the small motor may need replaced.
This project will take about 2 hours to perform but it is worth your time verses the cost the dealer will charge you.
On a technical difficult scale of 1 -10 ten being the highest....this procedure is about a five.
2007 Toyota... | Answered on Feb 01, 2017
466 questions posted
Usually answered in minutes!