20 Most Recent
1997 Toyota Camry Questions & Answers
97 Camry with ABS light continuously, but brakes
There is a fault in the abs system and the light is on to notify you that the system is not working. normal brakes will work fine. this will need professional repair as there are specific tests that can only be performed with a professional scan tool, not just a code reader.
Can't locate opening to add transmission fluid to 1997 Camry
Since My Scion XA is Made by Toyota I figure that there can't be a Whole lot of Difference in Motors. Same 4 Cylinder Toyota Motor that they use in yours. Does not have a Tranny Dipstick or Place to fill it. Dealer Service Item Only. I know it sucks.
97 Toyota Camry aut. door lock and dash clock not working properl
i HAD the same problem.... first check the fuse under the hood labeled 'dome' should be a 7.5A it is blown for sure... also if you are good with wiring and at working on cars look at the drivers side doo wiring (between the inside door jam and the drivers side floor... its the wiring that goes through the door to the cabin.... anyway you have to take off the door panel and remove a small cover on the floor of the drivers side.... now remove the two connectors that go to the wiring harness.... you should now be able to loosen the grommet and pull the wiring harness through the door via the speaker hole (you should have removed the speaker already) you now must inspect the wiring which is most likely frayed and/or broken now fix the wiring with some new wiring and crimp connectors and heat shrink your work.... should be good as new... have fun getting the wiring back through the door... it will be bigger due to the crimp on connectors etc..... i did a quick write up of this so i hope it is understandable
1997 camry passenger side door damage battery drain
If the left side is hit with a car you might have damage to the cables that run in the floor channels that are below the door when the door is closed the plastic that the door is on when the door is closed. Suggest removing the plastic and checking the cables are not touching other exposed wires or the car body. If they are get insulation tape and wrap on exposed wires.
My car is not moveing, and it takes lots of fuel
That means you need the Oxygen Sensor, Knock sensor Camshaft position Sensor is usually on the outside of the timing cover which is a good thing. . Bank one simply means you are in front of your engine and you would pull the wire from the Number one spark plug and that part of your engine is bank one. The opposite side is bank two.
I would have the ECM (Engine Control Module ) checked. So many sensors going bad at the same time is just not normal. It's something that only a professional can do . Sorry about that. But to replace all those sensors one at a time would cost you not only money but a serious amount of time.
Not finding what you are looking for?