Welcome to Fixya
Here's the procedure on how to remove and install the ignition switch.
Removal
1.1
Disconnect the car's negative battery cable.
2.2
Insert the key into the lock cylinder and turn it to the Accessory position--turn it to the left. Make sure the front wheels are facing straight ahead before you do this.
3.3
Pry off the covers on the sides of the steering wheel concealing the air bag's mounting screws. Remove the screws with a Torx wrench, pull the air bag off the wheel and disconnect its electrical connectors.
4.4
Remove the steering wheel--unplug the electrical connector to the horn and cruise control, remove the wheel's retaining nut with a wrench, mark the hub's relationship to the steering shaft with tape and remove the wheel with a steering wheel puller.
5.5
Remove the steering column covers by removing the two Phillips screws on the sides and separating the two halves of the covers.
6.6
Unplug the electrical connectors for the ignition switch.
7.7
Unscrew the retaining screws for the ignition switch with a screwdriver and pull the switch out of the lock cylinder's housing.
Installation
8.1
Insert the replacement ignition switch into the lock cylinder housing--the lock cylinder must still be in the Accessory position--and secure it with the retaining screws. Connect the electrical connectors to the switch.
9.2
Connect the steering column covers to the column and secure them with their Phillips screws.
10.3
Install the steering wheel to the column, then connect the air bag to the wheel with its electrical connector and Torx screws.
11.4
Re-connect the battery cable.
Thank you for using Fixya! If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b