20 Most Recent
1994 Toyota Land Cruiser - Page 2 Questions & Answers
Water leaks through air vent
I would pull the blower motor out and check the water condensation drain at the bottom of the blower motor housing, it is likely plugged with leaves or a mouse nest or both.
How can I get the security light to turn off
To bypass the factory security would be difficult or car thieves would have a field day!
your best bet would be to get a replacement alarm key fob and disarm the vehicle that way!
How to unlock 1994 Toyota land cruiser with out keys
I have locked my keys in my cruiser & found this the easiest way to get it open.get a wire coat hanger & straighten it out , make a hook on one end, now slide it down the drivers window between the glass & the rubber seal push it down about a foot or so & turn 90 degrees then slowly pull it up until you feel it grab on the rod that operates the door latch . You will know if you have it as the door button on top will move as you pull the wire up wards to unlatch , it may take a couple of shots , or you may be lucky & get it first go , dont forget to turn the wire back 90 degrees in order to pull it back out.
Good Luck Mick
I have a 94 Jeep Grand Cherokee Laredo v 8 5.2
If it's cranking, then the ground wire to the engine block is fine, Lee. It's possible that the little ground wire at the back of the engine, grounding to the body, got damaged, though - that's show up as no interior lights, no dash lights, no idiot lights, and any gauges failing to work. Easy fix, if that's what happened - run a heavy (#6) wire from the battery's negative (-) post to a big screw or bolt somewhere on the body near the battery.
But... there may be other issues getting in the way. Go through the standard checks - pull OBD codes from the computer, check fuel pressure & flow rate, check spark, check fuses. It's possible you pinched a wire between the back of the engine & the firewall, or pulled a wire connector loose from something. It DOES have gas, right?
Ignition switch will not turn on on a 1994 toyota landcruiser in the lock position
I would first try & move the steering wheel as you are trying to turn the ignition lock , it may take a few tries & also a fair bit of force on the steering wheel . This problem usually occurs with the steering wheel turned , ie the front wheels are not straight.Hope this solves your problem , let me know how you goCheers , Mick
Gauge not working or stuck
Could be sensor or float in tank , connect the wire on the tank unit to earth to see if fault it is tank unit there or the dashbord gauge .It should move if there is power
Not finding what you are looking for?