20 Most Recent 1996 Toyota RAV4 Questions & Answers

Where is the control module of rear defferential in Toyota rav4 2008

1996 Toyota RAV4 | Answered on Jul 09, 2019

The most common cause is that the ribbon contact drum under the steering wheel is faulty and has a broken filament. The part is called the "clock spring contact drum"

1996 Toyota RAV4 | Answered on Mar 05, 2018

yes, it has two relays. 2nd is a circuit opening relay located in the left kick panel

1996 Toyota RAV4 | Answered on Dec 01, 2017

Sounds like early stages of a worn out clutch slipping under load. If it is, make sure in the future to always take your foot completely off of the clutch pedal once in gear, or you will be replacing it again. In other words Do Not Ride the Clutch. Eventually you will have trouble going up hills, even in first or second.

1996 Toyota RAV4 | Answered on Nov 14, 2017

Your remotes may need to have batteries replaced and re-programmed.

1996 Toyota RAV4 | Answered on Jun 19, 2017

How many miles ?
Check tranny fluid ?

Sound like a tranny issue.

1996 Toyota RAV4 | Answered on May 05, 2017

Hello, it sounds like it's a bad front wheel bearing

1996 Toyota RAV4 | Answered on Apr 03, 2017

It is a NON-interferencene. All Toyota products with timing belts are non-interference. All Toyota products from 1998 on. with timing chains, are interference engines..

1996 Toyota RAV4 | Answered on Mar 12, 2017

Zero tolerance means the valves may have hit the piston when the timing belt broke. I would suggest doing a cylinder leakage test to see if the valves are bent or not. If the valves are not bent then you can replace the belt and everything will be ok. If there are bent valves then the cylinder heads will need to be removed and repaired.

1996 Toyota RAV4 | Answered on Dec 27, 2016

it called a oil pressure sender unit, its fitted near the oil filter.

1996 Toyota RAV4 | Answered on Nov 13, 2016

there is no oil in a knock sensor , are you sure you are not looking at the oil pressure sender unit , usually fitted at or near the oil filter.

1996 Toyota RAV4 | Answered on Nov 13, 2016

First off, it is 20 years old. First I would do a compression test, if good. The next thing I would do is a complete tune up. Cap, rotor, plug wires, plug, air filter, fuel filter, and an oil change with filter. After this I would start it and get it to operating temperature. Remove the air plenum from the carb/throttle body, Rev it up a bit (not letting it die) and pour a small stream of water in the throttle body for a minute or so. Doing this cleans the top of the pistons and valves from carbon build up.

1996 Toyota RAV4 | Answered on Aug 14, 2016

1 step 49 ft-lbf
2 step 90 degees

1996 Toyota RAV4 | Answered on Jul 12, 2016

William, Could not a lot on your particular engine, links below to show the basics on removal/install of cylinder head. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How to replace the cylinder head gasket on 96 Toyota Camry 4 cylinder
Replacing the head of VVTI celica engine 2000 2005

1996 Toyota RAV4 | Answered on Jul 10, 2016

Not finding what you are looking for?
1996 Toyota RAV4 Logo

528 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 Toyota RAV4
2002 Toyota RAV4

501 Questions

1997 Toyota RAV4
1997 Toyota RAV4

447 Questions

2004 Toyota RAV4
2004 Toyota RAV4

348 Questions

1998 Toyota RAV4
1998 Toyota RAV4

310 Questions

1999 Toyota RAV4
1999 Toyota RAV4

333 Questions

Top Toyota Experts


Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

RAV4 Toyota

  • RAV4 Toyota

Most Popular Question

possible 96 rav 4 knocker sensor leak

  • Cars & Trucks