20 Most Recent 2000 Toyota Tundra Questions & Answers


Check the connections on the battery,It sounds like one or both may be loose.

2000 Toyota... | Answered on Nov 16, 2018


you can spray around the engine with CRC or Wd 40or the like when its still fairly cool(for 100% safety)especially around the inlet area and it probably may start to run smoother ...you just need to look where its getting sucked in through the leak(temporarly sealing it)1 or so seconds maybe a little more and thats your answer unles a vacuum hose is off or split you havent spotted

2000 Toyota... | Answered on Mar 22, 2018


If you're comfy with manuals then i know few websites that can help you with it. Bcause I've bought it from various websites so I know how each site deals. try www.reliable-store com . Very helpful

2000 Toyota... | Answered on Mar 11, 2018


you will get one at www.reliable-store.com

2000 Toyota... | Answered on Mar 09, 2018


Your voltage regulator may be going out.

2000 Toyota... | Answered on Nov 20, 2017


the code reader would have identified which bank it pertained to so have the code read again
if the same shop say differently , take it to another place and have it read for free then comment with the code reported
you can then go on line to autodata web page and have the code identified

2000 Toyota... | Answered on Oct 20, 2017


i would buy a factory or nippondenso sensor. not some aftermarket junk

2000 Toyota... | Answered on Oct 01, 2017


No you do not need to remove the plenums. The starter is removed and installed from underneath the truck of from within the wheel well if the wheel is removed. You should go buy a Haynes or Chilton repair manual for $20 they are indisposable to do it yourselfers and will give detailed step-by-step instructions with pictures.

2000 Toyota... | Answered on Aug 25, 2017


Have you checked to see if you have any codes in the engine control module ? Even if the light is not on, it will store codes which are not a major problem.

Have you done any routine maintenance to your car lately, like a tune up ? Have you checked your air filter ?

2000 Toyota... | Answered on Jul 25, 2017


Your question has risen again by the look of it. It is now July 18th 2017. April has long gone.

2000 Toyota... | Answered on Jul 18, 2017


diesel engine --possible air in the fuel system
petrol engine check the fault codes

2000 Toyota... | Answered on Apr 16, 2017


Bleed the new caliper again and see if you have ABS. Sometimes those units gave to be bled too. Also check your manual or look online to verify the sequence for bleeding. Keep the master cylinder full through the entire process. If it drops too low, you likely pulled air into the lines and need to start over.

2000 Toyota... | Answered on Apr 03, 2017

Not finding what you are looking for?
2000 Toyota Tundra Logo

598 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Tundra Toyota

  • Tundra Toyota

Most Popular Question

need serpentine belt diagram

  • Cars & Trucks
Loading...