20 Most Recent 2002 Toyota Corolla Questions & Answers

button or switch sounds dodgy

see link https://www.youtube.com/watch?v=1QnZQPc8Wwc

Gear oil

Please describe the engine code for example 4A-FE, 3ZZ-FE and so on. For your convenience the timing chain installation for Corolla 3ZZ-FE is described below:

http://www.motorbooks.co.za/details.php?prod_id=4879

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything someone on fixya recommended it to me and I thank him even today

check oil levels every fill up of gas. if you see drop of level then, then check more often. same answer for 100 years,and will never change. (otto cyle engines, ICE) if not, say good bye to $3000 for a new engine. read the opr guide yet?

it's usually on the handle that turns on your lights usually you have to haul that handle toward you or opposite to turn on high beam or turn off high beam

The fuel pump relay is usually in the fuse panel under the hood drivers side near battery check to see if your car has a reset switch for the fuel pump just try another one of your relays with the same number to see if you can get it to work

usually inside the car drivers side there's a little panel comes off to access it should have fuse panel wrote on it

do you have a check engine light on I suggest you try looking at the oil control valve which controls your idling

go to a dealer shop or good locksmith to make a new coded key

The multifunction switch is the likely cause of this problem.

Pull the gastank and clean with approved cleaner. Stop running tank under a 1/4 you keep suckit all the gunk off the bottom

sounds like you were running it without oil..that would explain why there was no oil leaking on the ground..the gearbox would now be worn out so it's best to get another trans,, could be a rebuilt or from a scrapped crashed vehicle..if the trans was running out of oil, best not try to repair it..

You need to have the alarm module scanned by the dealer.

code p0440 refers to EVAP system malfunction==causes hose connections---intake leak---EVAP canister purge valve check for vacuum leaks (vents -auto control-manifold-brake booster etc). Check for cracked /loose hoses on the tank/filler neck