Top 20 2008 Toyota Highlander Questions & Answers

0helpful
1answer

On a 2008 Toyota Highlander, where is the purge valve located?

The evap purge valve is located under the hood near the air filter, towards the rear of the filter housing, it has an electrical connector and two vacuum hoses of about 1/2" diameter attached and one of the hoses has a fitting with a green cap on it.
4/26/2018 4:13:33 PM • 2008 Toyota... • 1,969 views • 0 helpful votes
0helpful
1answer

Horn and cruise control has stopped working on 08 highlander what is the fix.

...sounds like a blown fuse
5/28/2018 3:36:52 AM • 2008 Toyota... • 499 views • 0 helpful votes
1helpful
1answer

Rear speakers on my 2008 highlander don't work checked all plugs what now?

Lets start with the obvious. Is the Fader set to the front speakers only?
5/1/2018 11:59:48 PM • 2008 Toyota... • 456 views • 1 helpful votes
0helpful
1answer

Tire pressure warning light flashes

You most likely have a battery that has gone dead in at least one of your pressure monitors. If you take it to a tire shop they should be able to tell you witch one is inactive. They are around $50 for the monitor and they will charge you for a mount and balance to change it.
2/22/2018 6:30:06 PM • 2008 Toyota... • 387 views • 0 helpful votes
0helpful
1answer

The check engine light and VSC light came on in my 2005 highlander. 168,000 miles

P0420 & P0430 You need new catalytic converter The P0430 check engine light code, like P0420, means the catalyst system efficiency is below the required threshold. Simply put, this means your car is adding more pollution into the air than it's supposed to.
12/26/2017 10:36:03 AM • 2008 Toyota... • 1,072 views • 0 helpful votes
0helpful
1answer

2008 highlander hybrid, wont start

Have you checked the 12 volt battery under the hood? If it's low it won't activate the hybrid system and the engine won't turn over at all.
9/4/2017 9:36:49 AM • 2008 Toyota... • 832 views • 0 helpful votes
0helpful
1answer

When i start my car 2008 haylander it start some time but missing stop i have codc1201 engine control malunction cod1241 low or high power how can i fix

Take it to the dealer and have them "read" the codes. Suggest next time buy a model without built in "sucker" codes.
9/5/2017 12:33:25 AM • 2008 Toyota... • 94 views • 0 helpful votes
0helpful
1answer

Possible to upgrade vehicle GPS system?

here is a map update you may have to change the dot com etc but the web site has updates for all toyota maps http://www.toyota-mapupdates.eu/Shop/Index
5/28/2017 4:03:03 AM • 2008 Toyota... • 451 views • 0 helpful votes
0helpful
1answer

Hi, my wife has a 2008 highlander fwd and after slipping in some snow 4 dash lights came on. VSC off, brake, ABS, and traction control. Engine light did not come on. Dealer downloaded codes C1403, C14

Sometimes a computer reset can clear things up. Try disconnecting the battery overnight. When running the car for the first time after, make sure lights and a/c are off for the first 5-10 minutes or so while it idles and relearns the idle fuel mixture. This clears all the learned functions in the computer so it goes back through the relearn functions.
4/23/2017 1:12:03 AM • 2008 Toyota... • 1,105 views • 0 helpful votes
0helpful
3answers

Hi all I replaced the battery in a 2008 toyota highlander but camp get battery light off....Help. p.s the battery was bad per the parts store

possible not the battery but a problem alternator or regulator take it to an accredited auto electrician for a charge circuit system check
5/10/2017 1:03:51 AM • 2008 Toyota... • 164 views • 0 helpful votes
0helpful
1answer

Problem 1I have 2008 toyota

Your tire wear is something out of whack, bad wheel bearing, ball joint, strut, alignment, lots of stuff, a mechanic should be able to tell you what it is. Check out tirerack.com for tire and wheel packages that would give you a lot of different options and combos on different sizes. I had a car with 16" summer wheels and 17" winter wheels. Not sure about your vsc light, maybe bad senson in the bad bearing, but then seem like abs light would be on as well. Good luck. Hth.
5/8/2017 10:00:04 PM • 2008 Toyota... • 84 views • 0 helpful votes
0helpful
1answer

2008 Toyota Highlander Sprt whirring/vibration sound underneath

Catalyst converter heat shields or muffler shields. Do you live where you got snow?
3/25/2017 11:24:02 PM • 2008 Toyota... • 162 views • 0 helpful votes
0helpful
1answer

Where is the fuse for the rear tail light on a 2008 highlander

If you have only one bulb not working, or if you have only one side of the rear lights not working, it would not be a fuse. Fuses generally control , for example, all the rear tail lights, or all the front parking lights, etc. Those fuses are found in the fuse holder underneath the dashboard of the vehicle. If you have only one bulb out, either the bulb is burned out, or a socket for the bulb is defective, or the ground wire is not working. If you have one side out, you likely have a wiring problem. God bless your efforts.
1/1/2017 8:56:18 PM • 2008 Toyota... • 1,592 views • 0 helpful votes
0helpful
1answer

My 2008 highlander hybrid had a problem with the A/c cooling coil it had leaked. we have to take off the entire dash just to have it replaced. we had successfully place everything in order. but howeve

Hello, the P0420 code is common on corollas with higher mileage, you will need to replace the catalytic converter. The car will automatically be failed if the check engine light is on, Clearing the codes and taking it in to smog may not work because the cat monitor and others need to complete and pass, disconnecting the battery will erase all monitor information. It's not 40 drive cycles but maybe two or so after the repair, usually driving the car on both highway and stop and go city traffic with two drive cyles will complete the monitors, depending on what state you live in it may not be necessary to pass all monitors so ask your local smog station how many and which ones must pass.
4/14/2017 7:27:03 PM • 2008 Toyota... • 57 views • 0 helpful votes
0helpful
2answers

Changed the battery in my 2008 Toyota highlander now the radio wont work

You need the radio security code, it was given you when the truck was purchased new. If you are not the owner then go here for help www.radio-code.com or the dealer.
12/31/2016 7:02:41 PM • 2008 Toyota... • 869 views • 0 helpful votes
0helpful
1answer

Low beams do not work on 2008 Toyota highlander

The most common cause of this is the dimmer switch
10/16/2016 5:54:43 PM • 2008 Toyota... • 2,569 views • 0 helpful votes
0helpful
1answer

VSC and engine light are on. Why won't it move forward?

Here's are possible solutions to the VSC/Engine Light http://www.cargurus.com/Cars/Discussion-c3961_ds548625...Why it won't move forward is a separate issue sorry just one mountain at a time...Good Luck!
1/7/2016 4:52:23 PM • 2008 Toyota... • 1,008 views • 0 helpful votes
1helpful
1answer

Where is turbine speed sensor located on 2008 highlander

Hi there my name is Brandon I am a electronic and mechanical engineering technician I am the man that mechanics bring cars too when they cant fix them or cant find the electric problem I am a 4 generation mechanic but the speed sensor is next to the pl.sol. on the transmission
11/28/2015 4:17:03 AM • 2008 Toyota... • 538 views • 1 helpful votes
0helpful
1answer

2008 cd player broken no way to code

2008 Toyota Camry CD Player - Discussion on Topix

www.topix.com > Toyota Camry Dec 10, 2007 - #1 Dec 10, 2007. Just bought a 2008 Camry LE with standard CD player. ... Toyota will repair the CD player tomorrow morning. I still have a CD stuckthat I can't ... Toyota Highlander Radio Problem Aug 2, 2010 2009 Corolla Stock Radio Display goes Blank. Jan 18, 2010 2007 Toyota Camry Radio Reception Mar 17, 2008 More results from www.topix.com images for Toyota 2008 cd player broken
10/21/2015 10:32:53 PM • 2008 Toyota... • 917 views • 0 helpful votes
0helpful
1answer

Engine shuts off after driving 45 min when parking in reverse.But 15 min before this engine and slippery road icon comes on.2 hrs later car starts and drives normal then shuts off again 45 min later.

most commonly found problem relates to an electronic component heating up and shutting down. Have you checked to confirm there is fuel pressure when the vehicle shuts off. Is the check engine light on. Have you checked codes ? I suggest hooking up a fuel pressure gauge and letting vehicle run till it shuts off while monitoring the fuel pressure. If you loose fuel pressure, next step is to confirm there power going to the pump, if there is power going to the pump with no fuel pressure replace pump. Another suggestion would be to check for spark when vehicle stops running to eliminate an ignition problem. good luck
8/17/2015 5:03:34 PM • 2008 Toyota... • 318 views • 0 helpful votes
Not finding what you are looking for?
Cars & Trucks Logo

555 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Highlander Toyota

  • Highlander Toyota

Most Popular Question

rear speakers 2008 highlander dont work

  • Cars & Trucks
Loading...