20 Most Recent 2001 Acura CL 3.2 Type S Questions & Answers

Question edited for clarity. Question moved to model category. No, it is no a replaceable item and is located in the bottom of the fuel tank and is part of the fuel pump Attached to the fuel pump in the gas tank. It's not a replaceable part. You would have to replace the pump in the tank. Actually it is replaceable, but not a maintenance item. Apr 12, 2011

fuel filter location on 01 CL ? - Acura Enthusiast Community

AcuraZine https://acurazine.com > ... > 2G CL Problems & Fixes ..

do a compression test to check for loose valve seat insert replace injector check for faulty hydraulic cam follower jammed after being over pumpedr from high rpm

Yes the key Fob is likely in need of programming. You can do it at home with the instructions at the link below. If that fails time for the dealer to look into this problem. Acura CL 2001 Keyless Entry Remote Fob Programming Instructions

Seat back of cushion?

You can get the code for most makes here: radio-code.com

code p 1753 refers to AT-lock up clutch not engaging/disengaging===causes --wiring--lock up control solenoid A---TCM ( transmission control module I would start at the wiring harness and connections to ensure that all the pins are clean and straight then I would get a known good TCM and change it out to see if the fix was effective because you can get gears, I would at this stage disregard the clutch lock up control solenoid (torque converter clutch solenoid) maybe for an exacting diagnosis of the problem, a discussion and inspection by an accredited auto transmission specialist shop the deals with your make of vehicle would save money in the long run

Check wires. Mainly the battery wires. then work your way out. Start the car up and start shaking wires until it stops. If that doesnt work, then get a mechanic to look.

Only Ford products use an inertia switch for the fuel system.

This is a common symptom of the fuel relay. One of these times it is not going to start at the worst time. Get it checked out.

Tap on starter while someone holds key in start position. Check negative battery cable. Make sure battery good, terminals clean and tight.

Hey gorda!!!!! Miss u,, my email, [email protected]

Here are the instructions to test the braking switch and related components to locate the fault. Brake Pedal Position Switch Test 1.) Disconnect the 4P connector from the switch (A). 2.) Remove the brake pedal position switch. 3.) Check for continuity between the terminals according to the table, using a multimeter. 4.) If the continuity is not as specified, replace the brake pedal position switch and adjust the pedal height. 5.) If OK, install the brake pedal position switch and adjust the pedal height.

Question edited for clarity and make sentences.Remove the unit, remove the connectors, spray them with electrical contact cleaner and then replace them making sure they are well locked into place.Or there is a dry joint inside the unit.Start with the easy stuff first.https://www.google.com/search?q=Acura+RLX+radio+turns+off+every+time+I+hit+a+bump..

Unlikely :>D https://www.google.com/search?q=2006+Acura+MDX+navigation+system+code+for+free ..

Two ideas here, in the under hood fuse box or under the bumper. https://www.google.com/search?q=1998+Acura+CL.+Where+is+the+a%2Fc+clutch+relay+located ..

Unhook the negative post of the battery for a minute and that should reset the computer.