Peugeot 307 - Recent Questions, Troubleshooting & Support


Best to replace it, even if it was repaired could you rely on it in a crash.

Peugeot 307 Cars... | Answered on May 03, 2019


I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Peugeot 307 Cars... | Answered on Mar 21, 2019


There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few
for now u can try reliable-store.... let me know if u need help
thanks

Peugeot 307 Cars... | Answered on Feb 16, 2019


Get the service and repair manual from the given link this manual with a diagram will help you to locate and fix the problem on your own http://toolsnyou.com/

Peugeot 307 Cars... | Answered on Nov 05, 2018


Remove the cap from the fluid reservoir - fill the reservoir to the full mark.

Start the engine and slowly turn the steering wheel full lock left then full lock right. Repeat a few times. Then check the fluid level again.

Turning the steering wheel full lock should allow the fluid to get throughout the system. Any air in the system should vent to atmosphere from the reservoir.

Peugeot 307 Cars... | Answered on Oct 02, 2018


The bearings in the electric clutch are either going bad or it has collected dirt/debris inside of it. Grab a can of WD40 with the spray straw and aim the tip of the straw into the gap on the A/C drive pulley (there's one part that spins and the centre part that is static) Apply a liberal burst of WD40 and then start the engine and listen for the noise. Fingers crossed the noise will dissipate completely (*this may only be a temporary fix)

2005 Peugeot 307... | Answered on Sep 13, 2018


If you want to debug the problem yourself, the first thing to do is to buy a engine OBD2 scanner. When the code show up, you may see what is the problem using the OBD scanner and your cell phone, with the proper app (like Torque for Android).

Remember to check if you are buying a bluetooth OBD2 scanner, and your phone have bluetooth as well.

One more thing, the OBD2 connector on the Peugeot 307 is right behind the ashtray, remove it to have access to the OBD2 connector.

The most probable cause is the fuel intake, may be the fuel, a filter or even the electric gas pump. Just a OBD2 scanner will tell you accurately the cause of the problem.

Best Regards

2006 Peugeot 307... | Answered on Aug 30, 2018


Dont force open will break motors check fuse first

2006 Peugeot 307... | Answered on Jul 09, 2018


Normal thermostat operating temperature is around 80 to 85 degrees so that temperature is a little high. Does she do a lot of short, slower city driving or faster motorway runs.
Have you had the thermostat checked? I'm not sure whether that year uses the traditional type or the newer version with the heat sensor built in. I think it's the newer one. Thermostats are usually the best thing to check first as when they get old they start to fail and they are usually fairly cheap to replace.
If it was the water pump it would be noisy, leaking or both. So it would be worth getting a good mechanic to look at it.

Peugeot 307 Cars... | Answered on Jul 05, 2018

Not finding what you are looking for?

-430 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

scj103

Level 2 Expert

104 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Peugeot Cars & Trucks

  • Forum

View Most Popular

  • Peugeot Cars & Trucks
Loading...