Proton Gen2 - Recent Questions, Troubleshooting & Support
I have GEN-2 if i press the brake pedal all ligths on what is the posible problem?
It can only be a problem caused by a shortage, the wire activated by the brake as you apply the brakes is shorting ( touching) the other wires in the wiring loom, hopefully not too far down , unless you are competent and confident with a cars electrical circuit I would seriously suggest you get an auto electrician. B4 that Have a look and follow the brake pedal wire ( situated maybe on the floor of the car and activated as the brake pedal is pressed or on the pedal itself, )look for anywhere tge wire is bare ( without insulation ) then rectify and all should be OK , If you cannot see an easy fix get an auto electrician, get a call out , not a auto shop /garage he will be cheaper.
Car advice
If your car has automatic gears , and your problem as if it is going uphill then you obviously have a faulty automatic transmission box , this can be fixed by a competent mechanic but would be better to take it to an auto-mechanic, for a replacement gearbox or it may just be a missaligned gear selector in the gearbox, it will be expensive whatever the problem is ........unless the auto-mechanic is your best buddy..............................Sorry
2006 gen2 gearbox wiring
If it's auto, get it scanned for error codes before you do anything with the wires. The codes will guide your repair better.
Throtle sensor
It is an integrated model.The TPS is part of the motorized throttle body. If you have TPS error code. Clean the throttle body and reset it with a good scanner. If that does not work, you may have to replace it.
How to remove Proton Gen 2 Fuel pump
Remove rear passenger bottom seat. Find a round metal cover on the v=center of the floor.Pry it open. You will see the pump. Remove the wire connector and the fuel pipes from the pump. Unscrew the big plastic retaining ring and pull the pump cannister up.
Car has ingine problems itis getting hot or overheted
Check to see if radiator fan goes on when temp is about halfway on the temp gauge. If NOt running, check fuse and relay.If OK, check Coolant Temperature Sensor with scanner. Check the thermostat valve. Check water pump. Check clogged radiator.
How to change key battery
you may have dropped the RFID chip inside the battery housing. That chip is used by the immobilizer to recognize the key. Get your spare key and use it to start. If you don't have one, you will need to get your key replaced and reprogrammed.
Inertia switch
Inertia switch is only relevant when you have a collision and the engien does not start. Fuel pump may not run and coils no spark. If not, same thing could also happen if the immobilizer is not disabled or the key FOB gets damaged. The ignition key has an RFID chip in it and if you drop your key or remove this chip, the car will not recognize the key and wont start. You need to use your spare key from then on.
Immobilzer problem proton gen2
The ignition key holds a sort of RFID chip. If you open it to change remote control battery or you dropped it to pieces and the chip comes off, you will not be able to start your car. Get your spare key and use it to start. The key that cannot be used to start has to be replaced/reprogrammed.
Not finding what you are looking for?