Tip & How-To about Chevrolet Silverado

Battery Terminals & More

Today's tip is about battery terminals & how to protect them.
I have seen many opinions on this subject, the one i disagree with most seems to be popular among a few "experts" even on this site. So here is my 2 cents on the subject...

Is it a good idea to put Vaseline on battery terminal posts to prevent corrosion? - Not really, & this is why...

Under hood temperatures will cause the petroleum jelly to liquify, and run down between the cable and the terminal - effectively creating an insulating barrier.

I've cleaned up several of these well-intentioned mistakes that were discovered when a car would not start.

There is a battery terminal spray coating specifically formulated for the job, and available for a couple of bucks at the auto parts retail stores like Pep Boys, Auto Zone, etc....That is the correct product to use.

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

How can i install a horn without wiring


Aerosol Can Horn, would be the easiest way.
Without wiring, the Horn Button on Steering Wheel could not be used, sorry.
There are remote sensors made for just about everything, but might not find one for a Wireless Horn. That would be cool though.

Electric Air Horns.
Battery Powered.
Eazy to install. Mounts anywhere on car.
Has only 3 wires
Connect one wire to positive battery red terminal.
second wire to negative battery black terminal
Third wire has a switch attached, run that in to the inside of car
CAUTION ....It may be loud

Feb 26, 2017 | Cars & Trucks

1 Answer

if the battery harness for the terminals is corroded with lime calcium and rust and is getting a bad connection after trying to start the car a bunch of times could it send the car into protect


low volts wont harm the starting system
means the alternator is working well
maybe the battery is old

more attention to regular servicing
and checking under the bonnet required

try cleaning the battery terminals
if the connection are that crusty
baking soda and hot water
or replace the battery cable connections with new brass ones

May 19, 2016 | Cars & Trucks

1 Answer

Battery & alternator both good, but wont start without jump off, atleast once a day.


Your battery will not be "good" if you can jump start the car from another power source. If it is a 2014 model it will be the original battery.

Unless you have tested the cold cranking amps the battery is producing you cannot say if it will turn the starter motor or not. A good battery would kick the starter motor over. If you can jump start the car by connecting another power source to the battery terminals it will not be a wiring issue either.

If it's a 2014 it should still be covered by new car warranty (but not if the problem is just a failed battery which is subject to the applicable battery warranty)./

Jan 14, 2016 | 2014 Ford Fusion

1 Answer

2000 isuzu trooper no start with slow crank loose 4 volts at starter


automatic or stick>?
no engine size stated. gas or diesel.
slow crank, 250 -300 rpm is normal.
so did you AAA tow truck style , jumper cable crank that car off a running donor car yet>?
just that act (test) speaks volume for cause.

what does loose 4v mean...??
10-11v is normal voltage at starter. cranked.
4 v at the solenoid can not even begin to close it,
or did you mean the 12vdc is 4v lower that 12vd. which is 8v.
perplexing. (3 cheers 1st poster here with voltmeter, im am truly shocked,(no pun) honest reply.......!!

A fuses blown. (DEAD CRANKS)
DEAD BATTERY
BATTERY BAD
bATTERY JUST DISCHARGEd.
wrong sized battery in car, (tiny)
LAST DRIVE? the charge system died, and now battery is weak. fix charging system.
left head lights on, cure , charge battery.

battery terminals rusty !( yes they have 4 ends they can rust or get loose) 500 amps here so must be clean and tight.(bat terms)

jumper cables jump starts car ok?, yes, then battery dead.
battery bad, battery only discharged ?
next:
jumper cables don't crank fast, then hot wire the starter. (big wire to tiny)
more testing....
with known good charged battery (12.6vdc rested)
i hot wire the starter solenoid.
i monitor the voltage at starter actual.
with a volt meter.
most cars do 11v, in warm summer.
if much less, say below 10v the starter will be slow. so i monitor battery terminals volts.
and if ok, there, the cables are bad. (voltage drop on cables is that, yes, cables do fail.)
or the starter is partially shorted. or engine seizing....hand turn engine crankpulley and feel it.? feel normal, ? or cant move it...?

if i suspect a bad starter i use my ammeter.
the starter current will be about 200 amps .
no engine stated so.....i guess....
if it goes to like 600+, the starter is shorted.
I have an amp clamp amp meter, that allows me to see and find the hard cases...

May 15, 2015 | 2000 Isuzu Trooper

Not finding what you are looking for?

2,507 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Loading...