Tip & How-To about Dodge Neon

Dodge neon specs

The following articles apply to the 1st gen Dodge Neon.

VIN decoding
A/C Odors
Disable A/C during defrost
Swapping accessories on a stratus
Body & interior
Dashboard disassembly
Floor lights install
Front bumper removal
Passenger mirror install
Splash guard install
Stereo install‎
Radio elimination
Remote trunk release install‎
Window adjustment
Rotors & pads replacement
Always on fog lights
Battery relocation
Check engine light reset
Cruise control install
Engine diagnostic codes
Fog light bulb replacement
Lighted rear view mirror install
Coolant boiling
Engine removal
Fuel filter replacement
PCV oil restrictor
SOHC & DOHC interchangeability
Spark plug replacement
Borla muffler install
Exhaust manifold gasket
Monza exhaust
Oxygen sensors
Airbox removal
Kirk cold air intake
Nemo throttle body
Throttle body removal
Camber adjustment
Lowering 2nd gens‎
Springs removal
Steering column
Strut bars
95 Suspension options
Sway bars install
Toe & camber alignment
Manual conversion
Modular clutch
Motor mounts upgrade
Shift knob replacement
Wheels & tires
Tire sizes chart
Wheel vibration

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

2 Answers

how to manually reset computer codes on 2002 dodge neon SXT

You clear the codes with a code reader or scan tool. If the light came back on in two days with the same code the same problem came back.

Sep 26, 2014 | 2002 Dodge Neon

2 Answers

How do you remove/replace the AC belt? There are a lot how to's for serpentine replacement but none that tell you how to remove the AC belt which has to come off first.

loosen the center bolt of the a/c idle pulley, then on top of pulley you will see the adjusting bolt, turn to loosen to remove belt, after new belt , tighten to where you have 1/2 play on elt then tighten center nut of pulley

Feb 04, 2010 | 2000 Dodge Caravan

1 Answer

my1998 dodge neon speedometer works every now and then why?

I had this problem and nobody could figure out the why. After searching on the internet, I found the problem was coused by soldering issues on the circuit board for the gauges. My husband was able to resolder according to the instructions on a web page found at Neon.org. Search for speedometer and use 1st gen for the forum to search. This will bring results regarding fuses and resoldering. Unfortunately, the resoldering that was done only lasted about a year.

Nov 01, 2009 | 1998 Dodge Neon

1 Answer

i have 2005 neon sxt keep having code po457 evap emmission loose cap /off replaced cap from chrysler ck eng light comes back on same code anybody have any suggestions

fuel cap is just one of the causes. Here are 2 others:
  • possible vacuum leak
  • NVLD switch is stuck or malfunctioning
NVLD switch communicates with your car's computer. A bad switch will throw a P0457 error code. Check for a vacuum leak 1st but if none is found, the NVLD switch should be changed.
Below is a link that explains more thoroughly what the module does; I do wish you the best of luck with your Neon and hope you found this information helpful. Take care!

May 11, 2009 | 2005 Dodge Neon

Not finding what you are looking for?

1,931 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions