Tip & How-To about 2008 Suzuki Grand Vitara
I changed the starter. Remove engine cover and air intake. Disconnect battery. Remove front passenger tire. Put car on stands. Place small block of wood on jack and jack up onto the oil pan with slight pressure (not too much, just enough to hold in place.) Remove one belt from alternator by loosening left bolt on pulley and adjusting the tension on the other bolt of same pulley. Leave the other belt alone. Take out top bolt of alternator, loosen but do not remove bottom(this will allow you to lower or swing the alternator out of the way without removing. Undo wiring. Remove ground wire from starter. Take out motor mount (4 bolts). There are two Phillips screws holding a heat shield (square piece of metal) onto the starter. They have to be taken out or the starter won't be able come out (I replaced these screws with hex head bolts from Advanced Auto Parts for easier removal in the future. I'm sure they are at every hardware store). Slide the starter towards the front of the car. Remove terminal wiring and the starter is now out. The tools that I found useful were a ratchet with a flat head, metric sockets (8mm-13mm) and a swivel bit for the ratchet, an extra set of hands and 8 hours as I do not work on cars. The time consumption was greater than the difficulty. Once you understand heat shield has to come off and how it has to be done its not bad. You may have to softly bend some of the fuel line but only to fit the ratchet in from the bottom. You will have to do some work from the top and some work from the bottom.
Posted by Chuck D on
Jun 27, 2017 | Cars & Trucks
Apr 08, 2010 | 1992 Cadillac DeVille
Oct 23, 2009 | 1995 Plymouth Acclaim
Jul 13, 2009 | 1996 Buick Century
3,535 people viewed this tip
Usually answered in minutes!