Replace Front and Side Turn Signal Lights

If on the dash the arrow just lights but no blink. You have a blown light bulb on that side could be front or rear. Turn on flashers it should ID which blub
mike

faulty earth wire on the wiring cluster for the heat light check with a meter and fix the earthing point.

Replacing tail/brake/backup lights and turn signal bulbs (coupe)

1. Make sure the headlamp control

is in the OFF position and then

open the hatchback.

2. From inside the luggage

compartment remove the wing nut

of the rear light assembly cover.

3. Using a Phillips screw driver

remove the screw. The lamp is still

retained by a spring loaded clip.

Remove by gently pulling out the

light housing.

4. Turn the bulb socket counterclockwise as far as possible and pull it

out.

5. Pull the bulb straight out of the socket.

Install in reverse order.

Replacing tail/brake/backup lights and turn signal bulbs (sedan)

1. Make sure the headlamp control

is in the OFF position and then

open the trunk.

2. From inside the luggage

compartment remove the three wing

nuts of the light housing.

3. Gently pull the light housing to

the outside.

4. Turn the bulb socket

counterclockwise and pull it out.

5. Pull the bulb straight out of the socket.
Install in reverse order.

Replacing tail/brake/backup lights and turn signal bulbs (wagon)

1. Make sure the headlamp control

is in the OFF position and then

open the hatchback.

2. Using a screw driver remove the

fixings and trim from the body.

3. Remove the socket from the lamp

assembly

4. Pull the bulb straight out of the

socket.
Install in reverse order.


Hope this helps.

Zeppelinx12

the inner fender will provide a way. I would simply take it to a store and ask them nicely if they will do the install - -many times they will do it and at no charge. - if you must - -carefully pull away the inner fender from under the car - and look for the back of the marker -

DO NOT PRY on the plastic or you will break it and still not be able to change out the bulb.

Open up hatch , reach in and pull back liner, Remove nuts to release light lens. then push, turn and pull out bulb socket and same for bulb.