Saturn SL - Recent Questions, Troubleshooting & Support

If the problem occurs after the car has been driven long enough to reach normal operating temperature, the problem is the starter. If the 'no crank' occurs cold, retest the battery.

this device might be on a relay check under the hood for a power distribution box.. and see if there is a relay for this .. under the lid of this box is a diagram telling you which relay is which .. thanks Jerry

Take it to a shop and ask them to put it up on a lift, take a look and figure out where it is leaking. They can tell you and also how much to fix.

https://www.google.com/search?q=2002+saturn+sl2+idle+air+control+valve+location ..

Question edited for clarity. Question moved to model category. Hello namesake, I am also Andrew Taylor and have been since 1953! eBay or a local breakers yard https://www.google.com/search?q=1994+Saturn+SL2+replacement+seats ..

do you hear a hising noise if you dont your fuel pump is shot but if you do check your spark plugs and wires..also have some one give you cables see what happens

Fig. 1: At 90 degrees past TDC, the crankshaft sprocket timing mark and keyway will align with the main bearing cap split line.




Fig. Insert the timing pin to ensure that the camshaft is at No. 1 TDC-SOHC engine




Fig. : When the camshaft is at TDC, rotate the crankshaft counterclockwise 90 degrees to achieve TDC




Fig.: Insert the timing pins to verify that the camshafts are at TDC




Fig. : Make sure that the silver link plates and reference marks are all in alignment as shown


Hope help with this (remember comment and rated this).

Yea could it be in fuse block under hood

https://www.google.com/search?q=Need+to+no+where+mass+air+sensor+located+on+a+2002+cavalier+2.2+motor&biw=1363&bih=650&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwidypiQ58LQAhXJ7iYKHevTAvsQsAQIHQ#tbm=isch&q=Does+anyone+have+the+color+codes+for+the+2001+Saturn+SL1+radio+harness%3F Hope this helps

its the temp sender for the fans. its located on the back of the head

Porque golpea el carro cuando entra el cambio en reversa

I hate to tell you this, but there is not Camshaft Position Sensor on any 1.9L Single or Dual OHC. I assume you had someone read a Diagnostic Trouble Code from your PCM. They probably told you that you needed a Camshaft Position Sensor, and then offered to sell you one. I would recommend changing your spark plugs and your plug cables with FACTORY REPLACEMENTS. This will usually make the DTC go away. Aftermarket plugs and wires rarely work well for this engine. If you are looking for a CRANKSHAFT position sensor, look between the engine and transmission on the back side of the transmission. It is also known as the "transmission input speed sensor". More often than not though, your engine will not fire up if the Crank position sensor is not working. Hope this helps.

Your car came with 2 types of brakes for that year here is the DRUM BRAKE REMOVAL. I will have to send it in 2 posts since the text is too long to send it in 1 post. Please vote if this helps you:

Remove the wheels and brake drums.

Remove the lower return and adjuster springs using a universal brake spring remover. Do not over extend the springs or they will damaged and will need to be replaced.

Compress the leading brake shoe hold-down cup and spring while removing the pin from the rear of the backing plate. Release spring compression, then remove the hold-down cup and spring.

That is your low coolant level light. Add antifreeze/water mixture to the overflow resevoir

Under the floor board of the driver's side about where your left foot would rest.

Unless the cable is broke, it is probably your VSS. You might notice some harsh shifting if it is your VSS though.

Assuming it is an automatic transmission, I would look into that first. Check the fluid level. Low fluid level will cause hesitation. If your fluid level is ok consider changing the transmission fluid and transmission filter. Saturn's have an external filter, so it's very easy to do.

The reverse lights work off a switch near the brake switch at the brake pedal area. If loose it will not work. If tight its probably shorted out

the Vehicle Speed sensor is located on the upper left hand side of the saturn transmission...it looks like this.
Good luck..i hope this helps.

Sorry GM doesn't publish this info any more.