My brakes are leaking in the rear driver side need a diagram of brake lines to folllow.

contact a local mechanic

yep follows frame and inside gas tank to rear wheel well to above axle 1999 2006 Yukon Tahoe Suburban front to rear axle brake line replacement... 2004 chevy tahoe brake line diagram Google Search the 3 diagram is the front to rear

You will need a special tool for the back brakes,Autozone will loan it to you for 60 bucks,you will get it back when you return,I used it.I replaced brake pads front and back and both back rotors.The driver side rear had metal on metal,all disc brakes,brake pads on that rear side were completely worn down to metal,the driver side was like new,kept wondering why,replaced both rear rotors,put back together,then then I noticed where brake line hose went into brake caliber was leaking,so that caused the side with new like brake pads not to be gripping disc putting all brake pressure of that one side,so the copper fitting their was bad,put new one on and leak stopped.

your brake line is rusted and has a pin hole letting the fluid out. You will need to have the line replaced.

Yours will be similar to this one......................


20 Awesome brake line diagram 2000 silverado images

Brake lines by rear door on drivers side are a common failure point. lines under door failing can cause a total brake failure. Just replace and bleed the lines.

you have a leaking brake line and/or fitting. metal lines rust and break over time.

you most likely have a brake line rusted threw, cut the line ahead of the leak and after the leak and splice in a new piece of brake line, it will have to be steel, you can not use rubber. if you take the line to a parts store they can size it up and get you a piece of steel line and some pressure fittings to put it back together, after you repair the line then you will need to bleed the rear brakes.

It's a rear brake tee. Nothing but drilled brass. Might want to try checking the threads and flares on the brake lines that go into the tee. It's not often they crack and leak so inspect well. Let me know.

They don't make diagrams for brake lines. The lines are sold in bulk. You need to measure and duplicate the bends in the orignal lines and cut/flare the lines yourself. You will need a tubing cutter, flare tool and tubing bender.