SOURCE: Instrument Cluster Replacement
it will register the car it came out of and you can not change the milage you would nrrd to send it out
SOURCE: power door locks don't work on 2004 dodge ram quad cab
Maybe!!!! Wire taps are not a good thing. But yes I do them also... Kinda a catch 22! But the bad thing about wire taps are that they carode the exposed wires. Recheck the conections where you made the connection. If it breaks contact then the locks might not work. Or if the conection at that point is grounding out and blowing your relay or fuse. But if your tailgate lock still operated when all others did not then chances are that one of the door switches is bad. after you recheck your wires, disconnect the battery for about 10 to 15 minutes. If it is the relay then that should let it cool off and reset itself long enough to work or atleast hear a click out of the locks when you power up again. LISTEN CLOSELY FOR THE CLICK. Have someone inside of the car and up by the front of the car and this will increase the chance to hear it. You do not need the key on for the test because the locks have power all of the time. Good luck and let me know.
SOURCE: 2000 Dodge Ram 1500 (V8 5.2L) will not start
could be the battery, sometimes all the electrical would stay on but the battery doesnt have enough juice to crank the car over, if not check the alternater.
SOURCE: 98 Dodge Durango no electrical power
When the armed Vehicle Theft Security System (VTSS) senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed after the battery is reconnected.
The alarm can be disarmed by locking the vehicle and turning the drivers door lock to the lock (arm) position. Wait a few minutes then unlock (disarm) the drivers door and the vehicle should start.
If the VTSS has been disabled in the high-line Central Timer Module (CTM), the VTSS feature must be re-enabled using the Chrysler DRB scan tool. The clicking you heard was probably from the CTM located behind the glove box.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: light showing odometer and what gear transmission
The cluster will have to be sent out for repairs or exchange by a dealer or see Model Electronics.
100 views
Usually answered in minutes!
×