SOURCE: 94 GMC truck diesel starts,runs and then dies and will not start
I have the same problem and have trouble codes 35 and 36. I found out that there is a computer module that needs replaced as it sits low in a valley and gets hot and seperates. I am reseaching about the a/m fix that installs the new module away from heat.
SOURCE: 1997 gmc k1500 runs really rich
Hi there,first of all you must synch the cam/crank sensors. To do this put the engine on top dead center remove the distributor cap and look very closely at the dist housing there will be a 6 mark and an 8 mark loosen distributor and rotate untill the rotor points directly at the 8. The marks are small so get a light and look closely.Clear codes and restart. Is vehicle still running rich?
SOURCE: Truck will not run starts to run then sputters out
i just had this problem i changed everything then it turned out too be the fuel pressure regulator !!!!
SOURCE: where is the oil sending unit on a 2001 4.3 liter
ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT
TOOLS REQUIRED
J 41712 Oil Pressure Switch Socket
REMOVAL PROCEDURE
IMPORTANT: Clean the area around the sensor and Distributor before removal. Do not allow debris to enter the engine.
INSTALLATION PROCEDURE
112 views
Usually answered in minutes!
×