2001 gmc jimmy abs light staying on... Is there an abs breaker and where is it located?

Under the hood there should be a fuse box, it's going to be one of the big fuses, had the same problem, 01 Tahoe. Found out it was a front bearing assembly. I replaced and it works fine now. Be carful as you will have no abs once fuse is pulled and FYI the abs light and break light will stay on as well. Good luck

This is a common issue, and is pretty easy to fix. There are ABS sensors on the wheels, and you have a bad one. Usually the wires become corroded, and are easy to spot. The unit is on the back side of the wheel assembly.

yes its better to go shop and check what is the code so that u can easy to diagnose and repair..some problem of the abs light come in out is some abs defective or loose ,,or the abs motor ssy have problem or sensors in the wheel.

Both front wheels look for wire coming out of center.Either screw on to backing plate with allen head screw or are riveted.Look for wires out of rear wheels but you may see there are none. There may be one abs sensor in rear end. It will screw into the top.

It Sounds Like Your ABS Channels, Its A Separate Hydraulic Circuit That Feeds Out To One Or More Wheel Cylinders Or Caliper Pistons.Anti-Lock Brake Systems Can Have From One To Four Channels.

Could be an issue with the sensor or the wires connecting to the sensor as these are all exposed to the elements. It'll be located just to the inside of the wheel assembly

you need a chassis scan tool to read abs code & read date when stopping when this happens needs new frt sensor

its your blinker box.. all major lights run through there

Wheel speed sensors misadjusted, damaged , or metal shavings and other debree, since they are magnetic can give false readings from one of the wheel circuits. Over sized tires can give of false speed readings as well. there are many other causes including bad relay, control module, e.t.c. It is best to have the proper scan tool to diagnose an ABS problem

this is a abs pump problem. common on these circuits get "unsoldered" from vibration. if you feel like you can solder conections its a good couple hour job and sometimes things get burned out from voltage spikes. good luck jimmy rate as fixya thanx