1. With the key out of the ignition, unlock and open drivers door (all other doors must be closed)
2. Within 5 seconds,
Insert the key into the ignition (Do NOT Turn it) and Pull key out.
Insert the key into the ignition (Do NOT Turn it) and Pull key out.
3. Within 40 seconds,
Close then open the drivers door.
Close then open the drivers door.
Insert the key into the ignition (Do NOT Turn it) and Pull key out.
4. Within 40 seconds.
Close then open the drivers door.
Close then open the drivers door.
Insert the key into ignition and leave it in the ignition.
Close the drivers door. Turn the ignition to ON then back to OFF (Do NOT Start or crank engine).
Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the door locks do not cycle at this point or try the alternate procedure listed below.
6. Within 40 second,
A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
B. Immediately after letting go of the lock and unlock buttons, press and hold the lock button by itself.
Within 10 seconds, the door locks should lock and then unlock once indicating successful programming.
(If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted)
Repeat steps A and B in step 6 for each new remote.
7. Open drivers door.
Your remotes may need to have batteries replaced and re-programmed.
SOURCE: MR2 DOOR LOCK
sounds like some one tried to break into your vehicle and jammed the door locking rod this would be the most likley guess since you said motor is still working the rod will need to be pulled out and straightened again to factory bend this is critical
and your switch is on the door panel the one that says lock unlock
SOURCE: 2005 Toyota Sienna Sliding Door Won't Open
Have 2005 Sienna and its Driver side door was not openning. Cheap dealer fixed it himself in front of me. After opening the doors plastic assembly while sitting inside with a screw driver. Then he bent the clip towards left where the metal wire is connected. If you guys want to see what he did i would record a video and upload for you guys. Let me know at [email protected]
SOURCE: central locking not being activated by remote
somehow the car when on valet mode, go to a alarm shop , they should be able to re arm your car without to much damage to your pocket, or read your cars manual, it might inform you on how to fix the problem.
SOURCE: yaris 2003 remote control lock problem
You need to reprogram the remote. Please se this website:
http://toyotaownersclub.com/forums/index.php?showtopic=85266
SOURCE: Toyota RAV4 1995 Manual - free download
if they do and they have not got permission from toyota to reproduce said item,then they are headed for the courts.....you have to buy them in europe.....£18 each...
269 views
Usually answered in minutes!
×