SOURCE: 98 chevy s10 blazer turn signal
Unplug the turn signal relay from the fuse box and start you engine. Does it still make that noise?
If yes... Put the relay back in, that is not the problem.
If No...Then the relay could be bad, replace it!
PLEASE RATE THIS SOLUTION! Thank You Very Much!
SOURCE: had new blower put in Chevy 2002 S10 in 2007 and it is out again.
did they chg. the resister when this was done? if not, than thats your problem. heater blower motor resister controls speed of blower. most of the time before it goes out completely it will only run on a couple of speeds or maybe just one speed, but eventuly quit compleatly. sometimes the plug for the resister burns and that has to be chg. too. if you still got your recept from this job i would see if its got a breakdown of what they got listed as far as parts they replaced. if this was done at a dealership i'll bet the 411.00 was just for replacing the heater motor.
SOURCE: 89-98 chevy blazer
It's not worth doing all that conversion, buy the time you spend the time and money to convert the 89 4.3 to work on the 98 blazer, it would be cheaper to install a 98 vortec rebuild. The 89 4.3 have a TBI fuel injection system and the ecm on the 98 will not work and the bad news is that the ecm on the 98 also controls the transmission shift points and the 89 will not, so even if you swap the ecm to have the 89 4.3 engine work. the transmission will not shift. Sorry for the bad news but it would be cheaper to replace the 98 engine with the years of 1996 to 2001. Good luck and hope this helps.
SOURCE: 98 chevy s-10 codes p0131, p0171, and p1133
http://www.obd-codes.com/
go there look up the codes there all there
SOURCE: how to change crank senor on 99 chevy s10
Please opt for a scan as this will reveal to you if your sensor is faulty.
878 views
Usually answered in minutes!
×