Question about 1999 Chevrolet Silverado 1500

1 Answer

1994 Chevy suburban 4x4 had rear end done and when driving at speed 30 mph makes noise when it comes to slow down

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 22 Answers

Pinion depth was not set properly when the rear end was done, take it back where you had it done. Probably by now the ring and pinion have suffered unrepairable damage and will have to be replaced again.

Posted on Oct 27, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

What causes noise in rear?


Probably something wearing out back there.

May 21, 2014 | 1994 Plymouth Sundance

1 Answer

I have a 96 Suburban 2500 it has a humming noise coming from the tranmission between 45 and 60 mph but no perceivable noise below and above those speeds Can you tell me what might be the cause Thanks"


two things you want to check u joints at drive shaft and also check your rear end check for play where drive shaft joins to rear end and transmission let me know

Dec 02, 2012 | 1996 Chevrolet Suburban

1 Answer

Have a rumbling noise in left rear wheel while driving down the road 1999LexusRX all wheel drive.sounds like a wheel bearing.


Have the car put on a rack and have the noise listened to with a mechanics stethoscope to confirm the wheel bearing is at fault.

Sep 04, 2012 | Lexus RX 300 Cars & Trucks

2 Answers

My 97 geo metro started making noise that resembles a high pitch hiss, and it only starts making the noise above 30-40 mph and when i slow down it keeps on making the noise. I tried to put in neutral as I...


Could be Transmission related. Have you checked the Fluid level?
Also have you changed anything recently like new tires? Its not uncommon for some tires like (Hankook for example) to make road noise?

If you need further help, reach me via phone at https://www.6ya.com/expert/john_411a7faba7ce8217

Aug 18, 2011 | 1997 Geo Metro

2 Answers

Front end shakes hard at 30 mph


is it a 4x4? check the front u joints.

Nov 17, 2009 | 1996 Chevrolet Suburban

2 Answers

1994 Chevy Astro has two distinct noises. AT 40


Hey First thing I always look for is cheapest thing to repair or look at .. Make sure your tires are not cupping .. or make sure they are wearing good and smoothe all the way around .. this can make a terrible noise if they are cupped or worn improperly.. then I would Jack up one side and shake the rear wheels make sure those bearings are tight feeling .. you should be able to tell if they are loose this way ... I dont know how many miles are on your van but usually the drive line is not the problem.. this is probably last thing you need need to shake and see if there is play in it.. Holler if you need more and thanks Jerry

Apr 22, 2009 | 1994 Chevrolet Astro

1 Answer

1997 diesel suburban steering goes left


I doubt it's your 4x4. Most transfer case will start turning the front driveshaft, meaning that BOTH front wheels would try to turn.

Could be a brake pad/caliper locking up on your left wheel. That'll make that wheel turn slower resulting in the veering left.

Could also be a wheel bearing. However usually you'll hear a grinding noise to go along with that. And it'll pull rather consistently in that direction rather than suddenly.

Or, what first comes to mind is that your steering box is loose, or the gear inside the steering box is stripped in one spot. Or your front tie rods could be shifting or possibly ball joints. These would cause a sudden shifting/veering.

All of these things are front end related. And also very dangerous. Take it down to any alignment shop, have them put it on a lift, and diagnose immediately.

Worse case scenerio is that a front end part breaks and sends you out of control and into someone else. Please get it checked. A diesel Suburban could do a lot of damage.

Feb 10, 2009 | 1999 GMC Suburban

1 Answer

4x4 light and knocking noise after driving


If you hear the noise after the engine is turned off that noise is most likely the exhaust system cooling down. As far as the light for the 4 wheel drive that requires a test be run with a special scan tool while the problem is occurring.

Apr 20, 2017 | 1994 Jeep Grand Cherokee

1 Answer

Clicking noise in front end when 4x4 is ingaged.


Have the front hubs and CV joints checked, that is where this kind of noise most commonly comes from.

Dec 16, 2008 | 2003 Chevrolet Silverado 1500

5 Answers

HOwling noise from 99 Suburban 4X4


might be one of your catalytic converters clogging up. usually happens after engine has been running for a time? mostly heard when you let off the gas pedal? does the noise appear to be coming from the transfer case area? i thought i was having tranny problems, but turned out to be one of the catalytic converters. whew....

Oct 18, 2008 | 2002 Chevrolet Suburban

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...