I have the same problem with the service power steering system message is on.
Anyone have an answer how to clear this message?
SOURCE: 2001 Dodge Ram, 3500, CTD 5.9, AT, 2WD, No Bus
No bus error code has nothing to do with your fuse panel this is a ECM /ECU error code... sorry but get ready to spend some money for a new ECM
SOURCE: How to change transmission fluid and filter. 2004 dodge ram 3500
remove trans oil pan. there you will also see your trans filter,
SOURCE: how to reset
Try turning the key on,and pushing the gas pedal down slow within 5 seconds,this should clear the light off.
SOURCE: 2001 Ram 3500 Truck: replacing powersteering pump on 1999 dodge 1 ton 3...
it is best to remove the pwr st. pump and vaccum pump assy as a unit which is held to the front cover w/2 15mm head bolt and a support bracket on the bottom bolt next to the block @ the pwr st pump. and disconnect all lines. get the seal kit and replace them @ this time. if you don't and just replace the pump you will probably develop an oil leak where the shaft meshes w/ the adapter.
SOURCE: Charging problem on 1996 Dodge Ram 3500 Cummins Turbo Diesel
I had the same problem on a 94 dodge with the cummins. It seems the crank sensor that reads from a notch on the harmonic balancer was the problem Without this sensor reading that the engine is running the alternator wont charge. Possibly the same problem with yours
1,988 views
Usually answered in minutes!
×