Where is the egr valve on a 2006 dodge ram 2500 hemi 5.7?

Todd Bradshaw

• 141 Answers
• Posted on Feb 14, 2009

SOURCE: blower motor makes loud noise when on high

BLOWER MOTOR MAY BE GOING OUT ARE YOU MAY HAVE SOMETHING MESSED UP IN IT

ZJ Limited

• 17989 Answers
• Posted on Sep 07, 2009

SOURCE: egr valve location on dodge ram 2005 4.7

The EGR, or exhaust gas recirculation valve, takes inert exhaust gasses drawn from the exhaust system and reintroduces them into the combustion chamber through the intake manifold. This process lowers the peak combustion temperature and helps combat the formation of Nitrous Oxide (NOx) in the exhaust.

1. Separate the intake ducts from the air cleaner assembly by loosening the retaining clamps and pulling the ducts away from the housing.
   
2. Disconnect the vacuum line from the air cleaner assembly.
   
3. Remove the wing nut that secures the air cleaner housing lid to the base.
   
4. Remove both the air cleaner hosing lid and base.
   
5. Locate the EGR valve. Look at the front of intake manifold. The EGR valve will be bolted to the intake manifold just in front of the carburetor.
   

Automotive repair and diagnoses

• 8 Answers
• Posted on Sep 12, 2009

SOURCE: how to install egr valve on 2006 dodge grand

You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.

SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram

If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.

SOURCE: how tro replace heater core in 2003 dodge Ram PU

dodge want $800 to$1000 for doing this and I can see why.You have to raise or remove the whole dash recover you a/c freon ,disconect your a/c lines and heater hoses remove your heater box and put on a work bench remove the top and remove heater core,now next the last one I did the new heater core will not fit you have to modify the box so your new heater core will fit,put it all back together and fill with coolant and charge a/c, man I got tirered just typing this much less doing it, I hope this helps