Install crank sensor on a 1999 mitsubishi galant need a diagram of the engine.

Here!

Fuse box diagram Mitsubishi Galant

fusesdiagram.com > mitsubishi > fuses-and-relay-mitsu...

Fuses and relay Mitsubishi Galant 1997-2004. For the Mitsubishi Galant (EA) 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 model year. Fuse box in passenger ...

Fuse Box Mitsubishi Galant 2000 - Wiring Diagram

cars-trucks24.blogspot.com > 2018/02 > fuse-box-mits...

Feb. 1, 2018 - How to replace fuel pump 2000 2005 mitsubishi eclipse. For the mitsubishi galant ea 1997 1998 1999 2000 2001 2002 2003 2004 model year.

The Galant Center

www.thegalantcenter.org > showthread > 51323-Questi...

tamim13 said: 07-04-2012 02:41 PM ... 2nd picture is my fuse box (under the hood - taken from the drivers side facing the fuse box) ... I need to check my owners manual to see if the fuse diagram has an explanation of the relays as well.

Your 1999 Mitsubishi Diamante is a 3.5L MFI SOHC 6cyl engine.
MFI = multi-port fuel injection
SOHC = single overhead camshaft
This answer covers Mitsubishi Diamante1.8L, 2.4L, 3.0L (SOHC and DOHC), 3.5L, and 1997-2000 1.5L Engines.

2.4L engine shown, others similar.

Fig.1 - CKP position and its two mounting bolts


In Fig. 1, the two arrows point to the CKP (crankshaft position sensor) mounting bolts to remove. 2.4L engine shown.

Fig.2 - CKP reluctor removal

Remove the sensor and slide the reluctor wheel off of the crankshaft-2.4L engine shown.

1. Disconnect the negative battery cable.
2. Remove the timing belt.
3. Unplug the sensor connector.
4. Unfasten the two retaining bolts, then remove the CKP sensor from the vehicle.
5. Installation is the reverse of the removal procedure.

Reference: Autozone online repair guide: Mitsubishi Galant/Mirage/Diamante 1990-2000, at
www.autozone.com

Fig.3 - photo - new 99Diamante CKP, a Wells part #SU4313

I know a website that has
every info on all vehicles and vehicle problems, with their solution In detail.. it's www.reliable-store.com

the camshaft position sensor is located behind the harmonice balancer remove balancer and timing cover once removed you will see it u will also have to remove the crank gear and timing belt be sure to reset the timing or mark the gears before removal hope this helps

can you move it by hand?what noise do you hear when trying to start.
is the gear from the starter full in the motor.are all wires connected.

Right here....

where it the crank potision sensor on a 92 mitsubishi diamante

HI' to find the crank sensor you need to remove timing cove, Is by the crankshaft pulley

sounds like the ground wire for the cranks sensor is rubbing on the timming belt idler pully