My starter went on my Aurora 1995 i took out the injectors / fuel rail y wont the plastic manifold come off do i have to disconnect it from throttlebody first? i took the bolts out of the manifold but it wont budge i was told i could lift it from passenger side with out taking the four torque bolts outta th throttle body never worked on one of these plz help me asap
SOURCE: change fuel filter on 1995 olds aurora
Hi, here is a step by step guide that will help you with the replacement of your fuel filter.
Step1
Put on your protective glasses and gather your tools. An assortment of
wrenches and screwdrivers are necessary. The ones you use will depend
upon the vehicle.
Step2
Elevate the vehicle. This can be done by using a jack and jack stands,
or drive-up ramps. Do not rely solely on a single jack, as this is very
dangerous.
Step3
Find the fuel filter. The location varies from vehicle to vehicle. It’s a safe bet to start your search near the fuel tank under the body. You can also reference your owner’s manual or call your local dealership.
Step4
Remove the protective covering that guards the fuel filter. Most
filters have some kind of plastic covering over them to prevent damage,
and can be removed by a common wrench, hex wrench, or screwdriver.
Step5
Remove the fuel lines attached to the fuel filter. There are a number
of ways these hoses might be linked to the pump, such as links,
brackets or clips. Use either a screwdriver or wrench, whichever the
attachments require.
Step6
Cap the fuel lines with a pencil or golf tee, and keep them tilted toward the drainage canister.
Step7
Remove the fuel filter from the assembly, noting which way it was
oriented. An arrow will likely be on the filter. It should be pointed
toward the engine, and away from the fuel tank.
Step8
Install you new fuel filter. Be sure that it is oriented so the fuel arrow points toward the engine.
Step9
Reattach the hoses and guard.
-WARNING-
Please rate and god bless:)
SOURCE: how to install a thermastat in a 1999 aroura
Here's a great article on to replace the thermostat. It's a relatively easy procedure...just make sure engine is cold.
http://www.motorad-of-europe.de/motorad2.html
SOURCE: help with thermostat replacement on 95 olds sierra
you need a very small stubby 13mm open ended wrench or a small stubby ratcheting wrench to get to the lower bolt..no need to take manifold or throttle body off. just air cleaner & tube to gain access.firt bolt,you need a swiveling 13mm socket & you can get that one..thermostat takes a rubber seal by the way...not a gasket..
Removal & Installation
Disconnect the Negative battery cable Relieve the fuel system pressure (you can do this by placing a rag over the schrader valve on the fuel rail and pressing in the valve stem--just be careful not to spray fuel on your eyes). Drain the cooling system. Remove or disconnect the following:
Clean the manifold mating surfaces.
Remove or disconnect the following:
Starter electrical connectors
Starter motor
Fig. View of starter motor removal and wires
To install:
Install or connect the following:
Fig. Intake manifold torque sequence- 4.6L engines
60 views
Usually answered in minutes!
×