I lost old remote i bought a new remote sat in drivers seat locked all doors put key in ign. 6 times hazerds flash 2 times put key in ign. turn to acc. push button on remote un lock door nothing?
It will not unlock the door the first time you push the button. This only registers the key fob ID into the computer. When you press the button on the key fob, press it only once and wait for the hazzard lights to flash twice again. Then open the driver's door. The key fob will not become active until you open the driver's door.
If your hazzard lights do not flash after you press the button on the key fob, there is most likely a problem with the key fob. Either it is not the correct key fob for your vehicle, or the battery is not in correctly or the key fob is defective.
The only other advice I can give you is to have it programmed with a scan tool. This way, the scan tool can verify that the computer in your vehicle is receiving the signal from the key fob.
It can be done either way, but if the "no scanner" way does not work, the rest of the system should be checked for possible problems.
Sit in the driver's seat of your Ford 500.
Insert the key in the ignition and turn it from "Off" to "Run" eight times within 10 seconds. The final turn should have the key in the "Run" position. You will hear the door locks engage; this means it is in programming mode.
Press any button on the remote; the door locks will engage again to confirm the programming. This must be done within 20 seconds of entering the programming mode.
Press any button on the second remote; the door locks will engage again to confirm the programming. This must be done within 20 seconds of entering the programming mode.
Turn the key to the "Off" position to complete the programming. The door locks will engage again confirming that programming is complete.
Decide on a series of five digits to be your personal code. Your code needs to be an easily remembered series or numbers.
Locate the keypad on the driver's door; it will be directly above the driver's door handle.
Press the buttons that correspond with the factory remote keyless entry (RKE) code. This code can be obtained from the dealership if it has been lost.
Activate the programming mode by pressing the "1'2" button within 5 seconds of entering the RKE code.
Delete the old code by pressing and holding the "1'2" button for two seconds.
Enter the new five-digit code that you created in Step 1. This must be done within five seconds of deleting the old code. The door locks will cycle when the new code is confirmed.
hope this helps you.
Hope this helps
858 views
Usually answered in minutes!
×