My turn signals and my Hazard Lights stays on but dont flash problem?

change it. most likely contains the flasher for turn signal also

I’m happy to assist further over the phone at https://www.6ya.com/expert/howard_977676954994c5b2

Guys hope yourl keeping well

Ive got a 1998 A6 2.8 Quattro
Ive changed the gearbox and the vehicle dont start now.
the engine swings from the starter but when using the key it turns once and nothing happens thereafter the key is locked in on position where im getting ignition lights

Can anyone help???

It could be your flasher relay going out. Should be under the dash.

Which indicators? You mean the turn signals? If so it's your hazard relay - built into the hazard light switch. Get a new one at the dealer or from www.ecstuning.com, change it out, and you should be good to go.

The relay is built into the hazard switch. It could be that or the turn signal switch. Try the hazard switch first (it's relatively cheap). If that doesn't do it, you'll have to replace the turn signal switch, which involves removal of the steering wheel and airbag.

The signal flasher is within the emergency flasher. It will usually make a lot of clicking noise when faulty though. Check all the bulbs on the car for proper operation. Good luck!

You need a new hazard light switch - the relay for the hazards and turn signals is built in. It's $40 or so at a dealership to buy a new one.

its the signal switch on the colunm NOT the hazard switch

Its common for the sockets to burn up.  If you installed and the lights are still coming on.  The issue is the hazard light switch is bad.  If it were me I would replace the burnt socket anyway since it has been damaged and replace the hazard lite switch too.

The flasher relay, which is actually part of the hazard switch, must be replaced. You have to pry off the trim piece around the hazard button and remove the switch/relay for replaceing. Note that the trim can be difficult to remove and the relay/switch is also tough to get out.