Hi there, could you please offer advice on the following problems on my 1.6 Golf automatic.
First indication of problems was a warning light on dash which shows a problem with the ESP. Dash switch not working. This some times does not come on straightaway other time it remains on after starting
The next problem was another warning light on dash (picture of engine).
Diagnostics check shows 2 faults detected
1. 16500 P0116 035 sender for Coolant temperature.
G62, implausible signal.
2.Motronic Engine control module (ECM) power supply relay- J271- electrical malfunction in circuit. Sporadic Fault.
3. ABS/EDL/ASR/ESP Mark 60. 1C0907379M. ESP front MK60 coding 11266. 1 fault detected, Engine control module. Read fault memory.
4.Airbag with side airbag and electric belt tensioner
1C0909605A 27 Airbag VW51 01 0006
1 fault detected 00532 007 supply voltage too low.
hope you can help
Thanks in advance
Bob Randall
Check all your grounds sounds like you have a loose gorund somewhere.
the fans are coming on becuase ecu is not seeing a signal from temp sensor and cuts them on by default
Clear the trouble codes with a scanner and see if they come back, when faced with many codes this is the best thing to do, the codes may have been set during some kind of work being done on the car, the real hard faults will return and switch on the light if the problem is still present this will occur in about 10-15 miles of mixed driving, like city and highway, this is called a normal drive cycle. Let me know what codes return if any at my email address of [email protected] for further free help with this.
Try first unplugging battery cable for ten minutuse, to reset ECM, and do a scan again, there are too many unrelated error codes at the same time
1,630 views
Usually answered in minutes!
Hi Ginko
Thanks for your advice, The diagnostic check was carried out by my local garage. They said that ECU relay was OK, I disconnected battery as advised, no change. I have replaced the Themostat unit complete with sensor the old unit was found to be broken on removal. Still have the same engine lights on on the dash were the same and the temperature gauge still not working. The fans come on immediately when ignition key is turned and continue running after switching off However,after checking fuses,I tried to start it again there were no engine management lights on at all, lights etc were working. I eventually managed to get the car started with no management detail showing at all no radio info or outside temp info in centre dashboard,no rev counter However when I apply the brakes the management info comes back including the recv counter, I am getting various messages,like airbag fault emmisions workshop. When put into driv all info disappears again. can anyone Help !!!!
There is no crash to set this off. Just showed up when we scanned for abs sensor. Will this code show when I get my car inspected in Mass.?
×