Need to remove starter in 1992 pontiac bonneville first time need diagram to learn how to remove stater
SOURCE: pontiac bonneville 1996 3.8 l a/c.
Below is the diagram you requested. Please return to rate this solution. Thank you very much.
Greg
SOURCE: 1995 pontiac bonneville serpentine belt diagram
the belt routing should be on the rad housing, under the hood and glued to the fan cover or find it in the owners manual.if this does'nt work then you need to make the grooved pulley's go to the v's and the flat sides go to the flat edges.
SOURCE: how to remove radiator on 1992 pontiac bonneville
Removal & Installation
On some vehicles, such as this 1998 model, remove the upper fan mounting bolts
Unfasten the upper radiator panel fasteners, then remove the panel
CAUTION
When draining the coolant, keep in mind that cats and dogs are attracted by ethylene glycol antifreeze, and are quite likely to drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless it is contaminated or several years old. To avoid being burned, do NOT remove the thermostat housing cap while the engine is at normal operating temperature. The cooling system will release scalding fluid and steam under pressure if the cap is removed while the engine is still hot.
Unfasten the hose clamp and disconnect the coolant reservoir hose from the radiator neck
Disconnect the remaining hoses from the radiator
On some vehicles, you must unplug the coolant sending unit electrical connector
Use a flare nut wrench to disconnect the upper transaxle oil cooler line
SOURCE: fuse panel diagram 92 pontiac bonneville
Remember that you have several locations to Fuse Panel; check in the Pontiac Bonneville - Owners Manual (page 266 and next) for details and descriptions...
Hope helps (remember rated this)
SOURCE: Serpentine belt diagram for a 2001 Pontiac Bonneville SSEI
these motors have two carrier pulleys and oone tensioner. lookinjg at the motor from the rightside of car the belt goes as follaws: crank pully to super charger from the left. the right side goes up to the lower carrier which will have the flat of the belt riding on it. from there the belt routes to the upper carrier
[ loop it over so the grooves ride
] and then under the tensioner any questions contact [email protected]
388 views
Usually answered in minutes!
×