How do i remove the cover and replace the map light bulbs in a 2006 honda ridgeline
SOURCE: RADIO CODE FOR '06 HONDA RIDGELINE
You will need to remove the radio from the das, and get the numbers off the back of it. Then you will need to call a honda dealership with your vin number and the numbers off the back of the radio. they will be able to get the code for it. The reason being, is for security, like if your radio was stolen a thief couldn't just reactivate it without the proper info.
Hope this helps!
SOURCE: 2007 honda ridgeline vibration in the steering wheel
I used to work for honda and found this issue only once. After checking the driveshaft, differential, and tires, i found that the drive axles were the problem with vibration in the steering or upon acceleration.
SOURCE: Replace the tail light in a 2006 honda ridgeline
Open the tail gate, and remove the 2 screws on the side.
SOURCE: Honda Accord Map Light bulb
the cover is removed straight down, slowly working it with a thin tool or butter knife. WD40 to front and rear edge (there's nothing medial or lateral). The cover has 2 Y clips on each side, one about half way, and one that clips straight off of the hinge post. There are no "tabs". It will eventually unclip straight down. Then can replace with a DE3175 LED bulb (V-LEDs.com)
SOURCE: HOW TO RESET LIGHT AFTER YOU SERVICE VEHICLE
depending on your vehicle options, turn the key to the off position and then either push the trip reset or the select/reset button and turn the key to the "on" position just before the vehicle "start" position, then wait 10 seconds and the light should go off. if not make sure the outside lights are off and set the parking brake and try again
180 views
Usually answered in minutes!
×