At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
You can remove the cluster and buy the bulb separate as far as the brake light it is either the float is bad in the master cyl. or you have low frt brake pads
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I would recommend checking the fuses for the dashboard lights. If no fuses are burned, there could be a possibility of the bulbs in the dash being burned. In any case, start by looking in the manual for fuses relating to dashboard/gauge cluster lights. Once you find out what fuse it should be go from there.
Did u change the bulb w/ the Honda's original BULB?
They have a different type BULB in honda, the amperage and the base contact is different from a regular bulb.
Hope that helps u out!
taah!
This is a warning message about a burned bulb of a car lamp. Check all car lightnings: tail lamps, headlamps, turn lights, stop lamps, reverse lamp, fog lamps, ... Replace bad bulb(s). That's all.
The brake light and the turn signal are the same bulb. Most of the time if the bulb on the dash stays on it is because a bulb is blown and thats the way it tells you.
Your dash needs to come out. These bulbs push into a plastic piece that "twists" into the back of the dash board. (About a 1/4 turn) Unless you can get at them from underneath, but I think it's to tight.
have someone stand behind ur car and check ur brake lights when u hit the brake and not ur tail lights when u turn all ur lights on. that warning light came on for me and i discovered a brake light out
i have replaced a few caps with the floats attached.
inplug the wire to the cap and see if the light quits blinking, if so replace the cap. dont leave it unpluged it could cause problems.
make sure its full enough of brake fluid.
×