Question about 1995 Dodge Ram

Open Question

How to replace vacuum pump 1995 dodge ram 2500 diesel 5.9

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: 2004 dodge 2500 diesel

It's a safety feature. They 'auto-lock' at 8 mph.

Posted on Mar 21, 2009

Ad

Anonymous

  • 3 Answers

SOURCE: water pump replacement procedure 2005 2500 dodge with cummins diesel

take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.

Posted on Mar 22, 2009

Anonymous

  • 1 Answer

SOURCE: Cruise control not working

The pump is located on the passenger side of the engine compartment, back by the firewall. Look in the middle of the firewall by the cowl and you'll see a small plastic line going into the cowl. follow it back and you will come to a T fitting. Follow it to the passenger side and it will go into the Vacuum pump that controls the Cruise control.If you follow it to the other side, it goes under the Battery box. this is where the Servo for the cruise is located. Check the lines for small cracks, wear spots or even breaks. The plastic line can get beaten up pretty easily.
The easy way to see if it is your vacuum pump, turn the key on and listen. you will hear 2 distinct sounds. The first sound will stop in about 15 - 20 seconds. (fuel pump?) the second sound is the vacuum pump. If it turns off in 45 seconds to a minute (or slightly longer) the vacuum pump is probably ok, as are the plastic lines. The sound of the pump stopping means that vacuum has been achieved and is holding vacuum. If it keeps running, the pump is bad or the lines have a break in them. If the lines have had a hole in them for a long time, the diaphragm in the pump will have gone south. This is not a servicable part and the pump will have to be replaced. The pump is available from a dodge dealer but most likely the parts guy will not have a clue as there is no picture in their manual and a very poor description. When talking to them ask for a "03 Ram 2500 CUMMINS Cruise vacuum pump"
The part costs $212.70

Posted on Jul 02, 2009

Anonymous

  • 83 Answers

SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram

If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.

Posted on Sep 26, 2009

arauzvictor1

Victor Arauz

  • 466 Answers

SOURCE: i need a diagaram of a 1995 dodge ram 4x4 vacuum

Ok you shipping this figure i hope will help you Thanks469f0a7.jpg

Posted on Mar 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace my windsheild washer pump on a 1995 Dodge Ram 2500 Diesel?


remove the washer jug and it should pop right out of the jug

Oct 17, 2010 | 1995 Dodge Ram 2500

1 Answer

2000 dodge ram diesel 2500 . What is a fuel injection pump mechnical failure? a fuel valve feedback circuit?


This usually happens when the lift pump gets worn and fuel pressure drops below 7lbs and the injection pump has to work harder by pulling in the fuel and will destroy the pump,your is probably a vp44 fuel injection pump it needs replaced and they are expensive 1200.00+ but also change the lift pump or change to a fass fuel system,if the lift pump went out and you replace the injection pump it will ruin it in a short time.
The injection pump is not an easy job to change or for a novice mechanic as it has to be set in time with the engine at top dead center,and then the whole fuel system needs to be bleed of air.

May 21, 2010 | 1999 Dodge Ram 2500 4WD

1 Answer

2003 Dodge Ram 2500 Diesel. October I noticed


Replace heater hoses, Sometimes the inner lining of hose forms pockets that plugs flow of fluid.

Jan 13, 2010 | 2004 Dodge Ram 2500

1 Answer

2001 dodge 2500 diesel oil leak in front of power


The power steering pump is piggie backed to the vacuum pump. The seal in the back of the vacuum pump has engin oil under presure behind it cousing a leak that gets worse over time. Cummins make a seal kit to fix this leak.

Dec 26, 2009 | 2001 Dodge Ram 3500 Truck

2 Answers

1995 dodge diesel will not start sometimes It just cicks .


Well diesels are known to be cold, I would chack out your fuel filter and fuel pump to see, if they are good or not.

Sep 13, 2009 | 1995 Dodge Ram 2500

2 Answers

Cruise control not working


The pump is located on the passenger side of the engine compartment, back by the firewall. Look in the middle of the firewall by the cowl and you'll see a small plastic line going into the cowl. follow it back and you will come to a T fitting. Follow it to the passenger side and it will go into the Vacuum pump that controls the Cruise control.If you follow it to the other side, it goes under the Battery box. this is where the Servo for the cruise is located. Check the lines for small cracks, wear spots or even breaks. The plastic line can get beaten up pretty easily.
The easy way to see if it is your vacuum pump, turn the key on and listen. you will hear 2 distinct sounds. The first sound will stop in about 15 - 20 seconds. (fuel pump?) the second sound is the vacuum pump. If it turns off in 45 seconds to a minute (or slightly longer) the vacuum pump is probably ok, as are the plastic lines. The sound of the pump stopping means that vacuum has been achieved and is holding vacuum. If it keeps running, the pump is bad or the lines have a break in them. If the lines have had a hole in them for a long time, the diaphragm in the pump will have gone south. This is not a servicable part and the pump will have to be replaced. The pump is available from a dodge dealer but most likely the parts guy will not have a clue as there is no picture in their manual and a very poor description. When talking to them ask for a "03 Ram 2500 CUMMINS Cruise vacuum pump"
The part costs $212.70

Jun 12, 2009 | 2001 Dodge Ram 2500 Truck

3 Answers

2004 DODGE RAM 2500 DESIEL


the transfer pump is going bad ...dodge has an intank replacement for your vehicle

Nov 11, 2008 | 2004 Dodge Ram 1500

1 Answer

Water pump replacement procedure 2005 2500 dodge with cummins diesel


take off old water pump. clean up area on the motor real good.do this by using a scrapper and cleaning slolvent. when thats all done put hi temp silicon on the block water pump and the put gasket on silicon. let dry for like five minutes. put in on torque bolts to specs.

Aug 22, 2008 | 2005 Dodge Ram 2500 Truck

2 Answers

Fuel pump location


should be a fift pumo left side rear on engine at or near fuel filter

Jul 18, 2008 | 1995 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

453 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...